RidgeMonkey XF2 PLUS User manual
XF2 PLUS PORCH EXTENSION
ESCAPE
BIVVY INSTRUCTIONS
2
XF2 Plus Porch Extension Assembly:
1. Remove the XF2 Plus porch extension awning section from the carry bag and connect it onto
the corresponding zip at the front of your previously assembled XF2 bivvy.
2. Inside the porch, assemble one of the supplied elasticated frame bars and attach it to the
Velcro tabs on the inside of the awning nearest the XF2 bivvy.
3. Clip the three short non-adjustable tension bars into their corresponding position to extend the
rstsectionofawningawayfromtheXF2bivvy.
4. Assemble the remaining elasticated frame bar and attach it to the Velcro tabs on the inside of
the awning area furthest from the XF2 bivvy.
5. Clip the three long adjustable tension bars into their corresponding positions between the two
elasticated frame bars and adjust to extend the awning.
6. To increase frame rigidity where required, secure with supplied guy ropes. Ensure use of guy
ropes if using just the awning without the zip on sides.
7. Zipontheside&doorsectionsandconguretoyourpreference,peggingwherenecessary.
8. Finally, adjust the height of the upright frame bars using the camlock style lower legs.
3
XF2 Plus Porch Extension Disassembly:
Disassemblyisareverseoftting.Alternatively,theXF2Plusporchextensioncanbestoredina
semi-assembled state to save assembly time on your next outing:
1. Remove all pegs, doors, sides and tension bars. Walk the remaining material and frame bars
towards the front of the XF2 bivvy.
2. UnziptheXF2Plusporchextensionandlayitontheoor,facingawayfromyou.
3. Unscrew the upright poles of the frame bars and place them parallel to the horizontal bars.
4. The XF2 Plus porch extension can now be rolled forwards to gather any remaining material and
place inside the carry bag until your next session*
*Note: see storage information
4
Storage & Aftercare:
Proper storage is one of the most vitally important aspects of caring for your new XF2 Plus porch
extension and every effort should be taken to ensure the it is packed away dry. If you need to pack
away the XF2 Plus porch extension when it is wet, it is of paramount importance that it is unpacked
and dried within 24 hours before being repacked dry. If stored when damp or wet mildew and rust
will be able to form, both of which can severely damage the product and its accessories.
Always store in a cool, dark, dry place away from sources of heat or moisture. If storing for extended
periods, we recommend unzipping the carry bag to allow fresh dry air to circulate.
RegularlycleaningandreproongyourXF2Plusporchextensionwillmaintainitsabilitytorepel
water. Use only clean, fresh water and a soft brush or cloth to clean your XF2 Plus porch extension.
Do not use detergents or chemicals of any sort and never machine wash or tumble dry your XF2
Plus porch extension.
5
Warranty:
RidgeMonkey provides customers with a comprehensive warranty of two years from the date of
purchase. Please keep your receipt in a safe place as it may be needed in the event of a claim. Your
warranty covers replacement or repair at our discretion in the event of a manufacturing fault. Cover
excludes damage arising from (but not limited to) misuse, neglect, improper storage, improper
cleaning, Acts of God and is valid when your product is being used for recreational purposes only.
No consequential loss may be claimed. This warranty is provided in addition to your statutory rights
in the country of purchase.
6
Warning:
• NEVER use any fuel-burning products inside or within close proximity of your Escape XF2 Plus
porch extension. Doing so can result in the accumulation of dangerous concentrations of
carbon monoxide which can be fatal.
• WhiletheEscapeXF2PlusporchextensionisbuiltusingCPAI-84ameresistantfabric,itisnot
reproofandwillburnifleftincontinuouscontactwithanopenameorotherheatsource.
FailuretokeepameandheatsourcesawayfromtheEscapeXF2Plusporchextensioncan
leadtorewhichmayresultinseriousinjuryordeath.
• Always peg down your Escape XF2 Plus porch extension properly to reduce the risk of loss
or injury. Enough pegs and guy ropes are supplied to safely secure your Escape XF2 Plus porch
extension in most situations, however it may be necessary to purchase additional pegs and
ropes for use in extreme conditions. Tightly tensioning your Escape XF2 Plus porch extension
with the included guy ropes further increases its strength and stability and we recommend
that you do so whenever possible.
• Always maintain adequate ventilation inside your Escape XF2 Plus porch extension at all times
to help reduce the build-up of condensation, moisture and odour. Use of the optional XF2 Plus
Groundsheet (available separately) will also help to maintain temperature and prevent the
build-up of condensation inside the Escape XF2 Plus porch extension.
7
Contact Us:
For any enquiries or comments concerning our products, please use the contact form on
www.ridgemonkey.co.uk or call our dedicated Customer Services team on +44 151 486 7070, and
we will respond to you as soon as possible.
Statement:
• Intherstinstance,we’reonlyabletoprovideafter-salesserviceforpurchasesmadedirectly
from RidgeMonkey. If you purchased your product through an authorised retailer, please
contact them for any warranty issues and they will manage the claim on your behalf. Your
statutory rights are unaffected.
• Please note that unauthorised trade reselling of RidgeMonkey products is prohibited. If you are an
established high street retailer and wish to apply for a RidgeMonkey trade account, please contact
HeadOfceon +44 151 486 7070
• All brand names and trademarks used in this instruction manual are property of their
respective owners and in no way endorse (or imply endorsement) of any product described in
this instruction manual.
• This instruction manual and all literature contained within remains copyright of
RidgeMonkey®. Any unauthorised copying, lending or reproduction without prior written
permission is strictly prohibited.
WWW.RIDGEMONKEY.CO.UK
Table of contents
Other RidgeMonkey Tent manuals
