RIGd Supply UltraPlate User manual


INSTALLATION GUIDE
UltraPlate™


Congratulations on your UltraPlate! You’re only a few steps away from hitting the trail.

RIGd Supply 1533 W Orangewood Ave, Orange, CA 92868 | [email protected] | 949-424-3057




Installing the RIGd UltraPlate™ to the UltraSwing™

First and foremost if you bought your
UltraSwing with a wheel-plate at the second
hole down, mount your wheel-plate and be
sure the bolts and washers are mounted from
the back side, with nuts facing the wheel
plate.
(This will ensure maximum clearance for
mounting an UltraPlate if needed.)








2


1. Bolt mounting brackets to the Ultraplate as shown with bracket arms facing downward. Make
sure the slots are aligned and hardware is pushed inwards. Take note that when installed
correctly you should read the “R” correctly and the button head bolts are on that side while the
bracket side reads a backwards “R”. (Figures 1 and 2)
Figure 1

Figure 2

Figure 3



2. Now fit your UltraPlate to the UltraSwing, the brackets should fit inside the channel of the
UltraSwing. If needed you can loosen the button head bolts to slide over where needed.

3. Hand tighten the 2 bolts by the handle.

3




4. Next, hand tighten your 4 remaining bolts into the channel from the outside in.

4



5. Go back the the 2 bolts by the handle and tighten them with 9/16 wrenches. Follow up with
the 4 channel bolts.


5




Congratulations, your UltraPlate is now installed!

6