RIGHT ANGLE PRL User manual

Instruction # 52599
www.raproducts.com
Version Dated: 8/26/15
Read all the instructions before beginning.
Page1 OF 3
K&A Manufacturing
6703 Zinser Street
Schofield, WI 54476
Phone: [phone]
Fax: [phone]
Power/Data Receptacle
Installation Instructions

800719
Page 2 OF 3
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: [phone]
Fax: [phone]
www.raproducts.com
Tools Required for Assembly:
Power Driver W/Adjustable Torque
#2 Phillips Head Driver Bit
Flat Blade Screwdriver
Hardware Is Drawn Actual Size
Instruction # 52599
ITEM # PART # DESCRIPTION QTY.
1 PRL Surface Mount Power/Data Receptac e 1
2 Use Existing 1/4-20 x 5/8 Phi ips Truss Head Machine Screw 1
3 800719 PRLB (Power Management) Bracket 1
4 50072 8 x 3/4 Phi ips Pan Head Recex Drive Screw 2
Existing Screw 50072
24
3
Step 1: Remove the clamp from the PRL 1by removing
the machine screw 2that holds it in place. Insert a
flat blade screwdriver between the bottom plate and
the body of the PRL and gently pry up the bottom plate.
Pull the clamp out from the body. Save the screw and
discard the clamp.
2
1
Step 1

4
1
Step 3
setting on the power driver.
3
1
2
Step 2: Insert the PRLB bracket 3into the seat
on the bottom plate. Attach it using the screw that
held the clamp in place. Orient the bracket as
shown at the left.
Step 3: Place the receptacle at the desired
location and attach it with (2) recex drive screws 4.
Do not over-tighten the screws. Use a low torque
Step 2
Page 3 OF 3
www.raproducts.com
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: [phone]
Fax: [phone]
Instruction # 52599