WATSON TONIC User manual

SIMPLE MEDIA ASSEMBLY INSTRUCTIONS
TONIC
V.1.02 12/17 INS-TWTM

2 Tonic Simple Media Table Assembly | INS-TWTM
SIMPLE MEDIA TABLE COMPONENTS
FASTENERS TOOLS
#2 Phillips
Worksurface
Support Rails
Legs
Screen
Cable Bin
Cable Bin Tray
Lock Bar
Media Mounting
Bracket
Media Interface
Bracket
Outside Support
Bracket
(Wide Worksurfaces)
Inside Support
Bracket (RH)
Inside Support
Bracket (LH)
5/32 Hex Key
#10x1” Truss Head Screw,
Zinc (122850)
1/4-20x1/2” Button Head
Screw, Black (490719)

3 Tonic Simple Media Table Assembly | INS-TWTM
Prepare Screen
ALay screen down holes side up.
BAttach worksurface support brackets
and cable bin using the supplied ⁄-20x⁄”
Button Head Screws (x8).
CUnits with an overall width of 72” or
wider will include outer support
brackets and additional
⁄-20x⁄” screws (x6).
Attach Monitor Mount
Attach the monitor mount bracket with
the supplied ¼-20x⁄” Button Head
Screws (x4).
(490719)
(490719)
1.
2.
B
A
C

4 Tonic Simple Media Table Assembly | INS-TWTM
Prepare Worksurface
AAssemble on a clean blanket or on carpet.
BWith the worksurface face down, attach the legs
using ⁄-20x⁄” Button Head Screws (x5 ea).
CAttach the support rails roughly halfway between
the legs and the flat edge of the worksurface using
#10x1” screws (3-4 ea).
Position Worksurface
APlace the cable tray into the cable
bin.
BWith the assistance of a friend,
position the worksurface up against
the screen on top of the support
brackets.
Note — It may help to place
the screen against a wall for
added stability during this step.
(122850)(490719)
3.
4.
B
A
C
A
B

5 Tonic Simple Media Table Assembly | INS-TWTM
Attach Worksurface
AOnce the worksurface is in position,
attach it to the screen with ⁄-20x⁄”
Button Head Screws (x7).
BUnits with an overall width of 72”
or wider will include outer support
brackets and additional
⁄-20x⁄” screws (x4).
Prepare Monitor
APlace the monitor face down on a
clean blanket or on carpet.
BAttach the interface brackets
using whichever screws your monitor
requires.
Note — Monitor not included.
(490719)
5.
6.
A
B
A
B

Attach Monitor
Hook the interface brackets onto the
media mounting bracket attached to
the screen. Make sure the brackets
are properly attached before
releasing.
Insert Lock Bar
Insert the lock bar through the media
mounting bracket and through the
interface brackets to prevent the
monitor from being lifted away.
26246 Twelve Trees Lane NW, Poulsbo, Washington 98370
360.394.1300 watsonfurniture.com [email protected]
7.
8.