RIKA FOX II User manual

- 1 -
FOX II
Instruction Manual

- 2 -

- 3 -
D I M E N S I O N S
Flue pipe connection with original angle pipe

- 5 -
S P A R E P A R T O V E R V I E W 1
Pos Designation Article number
Regulator cover grey metallic Z34384
Regulator cover black Z34385
1
Regulator cover copper Z34386
2 Wire cable stop (from serial
number 278 046) L01984
3 Ash pan L00618
4 Bolt Z32643
5 Cover centering bolt Z33324
6 Stone cover bolt Z34366
7 Flat gasket 8x2 adhesive 103693
Cover lid soapstone Z32594
Cover lid sandstone Z32942
Cover lid volcano green Z34098
8
Cover lid volcano red Z34099
9 Spacer Z28501
10 Spacer Z33758
11 Pressure spring 111831
12 Spring plate (Control lever) Z34373
13 Spring tensioner (door spring)
(from serial number 278 046) L01982
14 Locking plate (cable pulley)
(from serial number 278 046) L01526
15 Felt washer Z34144
16 Fire clay rear Z32590
17 Fire clay front right Z32591
18 Fire clay front left Z32592
19 Fire clay rear left/right Z32593
Front door grey metallic Z34378
Front door black Z34379
20
Front door copper Z34380
Front door complete grey
metallic B16505
Front door complete black B16506
Front door complete copper B16507
21 Door glass Z34319
22
Door handle B16508
23 Set screw for handle M5 104060
24 Setscrew M05 wire cable stop
(from serial number 278 046) 111864
25 Glass holder L00475
28 Disc spring 108908
Pos Designation Article number
Wood retainer blac Z32940
Wood retainer grey metallic Z32603
29
Wood retainer copper Z33481
30 Cooking cover Z10021
31 Fin plate connection rear E14179
32 Lamella left B15380
33 Lamella right B15381
34 Air regulation B16501
35 Flue gas connection Z10020
36 Gasket rope Dm12 100485
37 Regulator handle Z34374
38 Rotary control knob Z34343
39 Controller marking L01911
Rear panel grey metallic Z34370
Rear panel black Z34371
40
Rear panel copper Z34372
41 Shaker grate Z25946
42 Grate arm L00616
43 Shaker disk Z25948
44 Door spring (from serial num-
ber 278 046)
111999
45 Grub screw M05 108427
46 Grub screw M08 111700
47 Hinge Z34377
48 Hinge plate L01800
49 Sliding anchor Z34317
50 Slider L01912
51 Driving rod L01913
52 Lower hinge nut M10 111780
53 Cable pulley (from serial
number 278 046) Z33895
54 Stone retaining plate L01496
Side panel soap stone Z32595
Side panel sand stone Z32943
Side panel vulcano green Z34100
55
Side panel vulcano red Z34101
56 Door bearing L01413
57 Door adjustment plate L01909
58 Deflector plate top Z33323
59 Deflector plate bottom Z33588
60 Lock complete B12322
61 Wire cable (from serial num-
ber 278 046) Z34342
62 Cylinder screw 111860
63 Cylinder pin 111798

- 7 -
S P A R E P A R T O V E R V I E W 2
S E L F - L O C K I N G D O O R
Pos Designation Article number
1 Flat sealing strip 8x2, self-
adhesive 103693
2 Spacer (rod end bearing
lower) Z26185
3 Spacer (handle lock) Z10709
4 Spacer (door handle pivot) Z33772
5 Pressure spring 111869
Combustion chamber door,
grey Z34523
Combustion chamber door,
black Z34524
6
Combustion chamber door,
copper Z34525
Combustion chamber door
cpl., grey B16630
Combustion chamber door
cpl., black B16631
Combustion chamber door
cpl., copper B16632
7 Door glass Z34319
8 Door bolt
B16633
9 Rod end bearing 111748
10 Setscrew M05 104060
11 Glass retainer L00475
13 Handle lock L01641
15 Piston housing Z34527
16 Piston rod Z34528
17
Door handle fillister head
screw 108203
18 Round sealing strip Ø12 100485
19 Deep-groove ball bearing 111747
20 Headless screw M05 108427
21 Headless screw M06 111749
22 Headless screw M08 111700
23 Hinge Z34377
24 Driving rod upper Z34526
25 Driving rod guide bolt Z33959
26 Hexagonal nut M10 111780
27 Door support L01413
28 Shaft locking clip 109185
29 Cylinder screw 111860

- 8 -
E N G L I S H
C O N T E N T S
Spare part overview 1 ..................................................................4-5
Spare part overview 2/self-locking door .......................................6-7
Explanations to symbols ................................................................8
Packaging ......................................................................................9
Technical data ................................................................................9
1. Important information
General warning and safety information ....................................... 10
Prior to set-up ..........................................................................10-11
Important information on ROOM-AIR DEPENDENT and
ROOM-AIR INDEPENDENT OPERATION ................................... 11
2. A small study of heating
Suitable fuels ................................................................................12
Fuel quantities .............................................................................. 12
Maximum fuel quantity .................................................................12
Clean burning ...............................................................................13
Burning wood ...............................................................................13
3. Installation of the stove
Connecting the stove ...................................................................14
Connecting an external combustion air infeed .............................14
4. Operation
Fire lighting ...................................................................................15
Ash drawer ...................................................................................16
Operating the riddle grate .............................................................16
Control knob, rear panel….…………………………………..……….16
5. Assembly options
Retrofitting flue pipe connection top to rear connection ............... 17
6. Maintenance and cleaning
General maintenance ...................................................................18
Surface – texture and cleaning .....................................................18
Convection air opening ................................................................18
Cleaning the flue gas pipes ..........................................................18
7. Problem solutions
What to do if ..? ............................................................................ 19
8. Warranty
We guarantee ...............................................................................20
Warranty card...........................................................................23-24
Subject to technical and visual changes; setting and printing errors excepted.
EXPLANATIONS TO SYMBOLS
Important notification
Practical advice
Use plan for help

- 9 -
E N G L I S H
PACKAGING
Your first impression is important to us!
The packaging of your new stove provides excellent pro-
tection against damage. However damage to the stove and
accessories may still occur during transport.
Therefore please check your stove on receipt for dam-
age and completeness! Report any deficiencies to
your dealer immediately! Pay particular attention dur-
ing unpacking that the stone and ceramic panels re-
main intact. Scratches to the material can easily occur.
Natural stone and ceramic panels are excluded from
the warranty.
The packaging of your new stove is environmentally neu-
tral to a great extent.
The wood used in the packaging has not been surface
treated and may therefore be burnt in your stove. The
cardboard and film (PE) can be disposed of via the
municipal waste collection for recycling.
TECHNICAL DATA
As a stove of type 1, connection to a chimney already used
by other stoves for solid or liquid fuels is possible as long
as the chimney dimensions do not contradict this accord-
ing to DIN 4705 (Part 3).
Exhaust values for multiple use of the chimney ac-
cording to DIN 4705 or to dimension the chimney
according to DIN 4705.
Exhaust mass flow 7,4 g/s
Exhaust temperature 218,8 °C
Minimum feed pressure at rated useful heat 12 Pa
The owner of small firing systems or the person
authorised for the small firing system is to keep the
technical documentation and is to submit it to the
authorities or the chimney sweep on request.
TECHNICAL DATA
Dimensions (mm) and weights (kg)
Height: 1039
Width: 550
Depth of the corpus 495
Weight excluding casing: 143
Weight with soapstone casing: 249
Weight with sandstone casing: 219
Flue pipe outlet diameter: 130
Rated useful heat according to EN
13240
8 kW
Smallest thermal output 4 kW
Room-heating capacity depending
on house insulation
90-210 m3
Fuel flow 2,2 kg/h
Efficiency 81,4 %
CO2 content 9,2 %
CO emission rel. 13% O
804 mg/Nm3
Dust emissions 28 mg/Nm3

- 10 -
E N G L I S H
1 . I M P O R T A N T I N F O R M A T I O N
Please read these instructions before installation and
operation. Observe the national provisions and laws
as well as the regulations and rules applicable locally.
GENERAL WARNING AND
SAFETY INFORMATION
Observe the introductory general warning information
- Read the entire manual thoroughly before putting the
stove into service.
- Only approved transport equipment with sufficient
load carrying capacity may be used with your heating
appliance.
- Your heating appliance is not suitable for use as a
ladder or stationary scaffolding.
- The burning of fuel releases heat energy that leads to
extensive heating of the stove surfaces, doors, door
and operating handles, glass, flue pipes and possibly
the front wall. Refrain from touching these parts with-
out appropriate protective clothing or equipment e.g.
heat-resistant gloves or means of operation (cold
hand).
- Make your children aware of this particular danger
and keep them away from the stove during heating.
- Only burn the approved materials listed in the Chap-
ter “Clean burning”.
- The combustion or introduction of highly flammable or
explosive materials such as empty spray cans etc. in
the combustion chamber and storing them near the
stove is strictly prohibited due to the danger of explo-
sion.
- No light or inflammable clothing is to be worn when
post-heating.
- Placing non-heat resistant objects on the stove or
near it is prohibited.
- Do not place clothing on the stove to dry.
- Stands for drying clothes etc. must be placed at a
sufficient distance to the stove due to the danger of
fire!
- When your stove is burning, the use of highly inflam-
mable and explosive materials in the same or adja-
cent rooms is prohibited.
PRIOR TO SET-UP
1.1 Floor bearing capacity:
Ensure that the substructure is capable of bearing
the weight of the stove prior to set-up.
Modifications to the firing installation may not be per-
formed. This leads to loss of warranty and guarantee.
1.2 Flue pipe connection
Flue pipes pose a particular source of hazard re-
garding gas leaks and fire. Get the advice of an
authorised specialist company for the layout and
assembly.
Please observe the corresponding installation
guidelines for walls panelled with wood when con-
necting your flue pipes to the stove.
SAFETY DISTANCES (minimum distances)
1. To non-inflammable objects
a > 400 mm b > 100 mm
2. To inflammable objects and to reinforced concrete
bearing walls
a > 800 mm
b > 200 mm