RINKE MARDERSCHOCK S2000/30 User manual

BEECH MARTEN
or
CAR MARTEN
Extended warranty
If despite a regular installation of our
anti-marten system a damage caused
by marten takes place in the first year,
our company “Franz Rinke, production
and distribution” will be ready to
replace your repair costs up to a total
value of 50. In order to do so we
require:
the devices
the purchase invoice and/or
the filled in warranty cards.
the invoice for the installation
and engine wash (engine wash
is mandatory for this warranty
and has to be documented on
your invoice)
a photo and/or a sketch of the
installation
the invoice for the repair
The marten is an animal amenable to
natural law. Therefore we cannot
provide you with
a never-know-to-fail warranty for the
protection of your automobile.
MARDERSCHOCK – S2000/30
This basic device protects your vehicle from
damage by these small predators by emitting high
sound pressure within the ultrasonic range.
Attention! If a marten has already caused damage
to your car, you have to clean the engine
compartment thoroughly in order to remove the
marten's scent marks.
4' 260022 210016

Our company also features a stronger 200V-based anti-marten
system with a range up to 15 meters that protects attics, barns and
other large rooms.
The Anti-Marten-Sy tem
ba e device S 2000/30 + additional ound tran ducer
add-on S 2100/10
Install both devices for optimal protection
In tallation manual and requirement for the ba e
device S 2000/30
1. technical pecification
Upgrade with an additional sound transducer (model S2100/10) is possible and
recommended
operating voltage: 12V
current consumption (normal operation): Ø 11 mA
current consumption with S2100/10: additionally 8 mA
current consumption (power saving mode): Ø 6 mA
current consumption (stand-by mode): Ø 3 mA
sound frequency: sweep 16 to 50 kHz
sound output: 112 - 115 dB - depending on battery quality
max. ambient temperature: -40 to +80° C (-40 to 176° F)
Flash light fires three times per minute to light up the engine compartment
as an additional repelling factor against martens. Micro controller regulated
protection against deep discharge. The controller monitors the battery level
and consecutively activates power saving/stand-by modes requiring only
6mA or 3mA. Upon deactivation of the engine, a short whistle signals that
the device begins operation. This device is small, compact, splash-proof and
easy to install.
2. Mode of operation
Our devices emit ultrasonic waves with a frequency range of 16 to 50 kHz
(sweep), which are inaudible for human ears but very unpleasant for
martens. Observations have revealed that martens avoid rooms or places
that are exposed to a sound pressure of more than 100 dB in their ultrasonic
hearing range. NEW: Our brand new micro controller based flash light
provides an additional repelling factor against martens. If the battery level
drops, the device switches to power saving mode first and finally to stand by
mode to protect the battery's remaining capacity against deep discharge so
that the engine can still be started.
3. In tallation of the ba e device S 2000/30
Mount the device at a maximum distance of 50cm from the ground using
the included mounting kit. The sound pressure should already affect the
marten on the ground. The sound cone has to point downwards and must be
adjusted contrary to the direction of driving. The sound cone is comparable
to the light emitted by a flashlight. If you install the sound transducer add-
on, the sound sources must not cross each other. The cable outlet has to
face upwards.
4. Electrical connection for all type of vehicle
Connect the red cable to the positive pole (+) of your battery. Connect the
black cable to the negative pole (-) likewise. The brown, white and purple
cables are used to connect the sound transducer add-on S2100/10.
5. Device tatu
The device's ready status is indicated by a short whistle that sounds when
you switch off your car. This signal indicates that your devices has started
its operation.
6. In tallation of the ound tran ducer S 2100/10! Please refer to this
model's separate manual.
7. Warranty
Our company “Franz Rinke, Herstellung und Vertrieb” provides an extended
warranty of 24 months for our Marderschock system to the final customer,
starting from the date of purchase.
For registering a complaint, the final customer has to provide a copy of the
installation receipt which clearly states the serial number of the installed
device. Belated insertion of the s/n is not possible.
As part of this warranty we will reimburse the costs, up to 50 EUR, for un-
and re-mounting of a broken (but new) device. Additional costs will not be
covered by this warranty. Opening, disassembling or inappropriate handling
of the device will void this warranty. Technical data is subject to change
without prior notice.
4' 260022 210016

Do not u e high pre ure cleaning in the
proximity of our device !
4' 260022 210016
Franz Rinke
Herstellung und Vertrieb phone: [phone]
Farnweg 5 fax: [phone]
D-86161 Augsburg email:
marderschock@franz-
rinke.de