RIOTEC DC9257A User manual

1
Programming Quick Guide
-DC9257A:Docking Scanner
-DC9267A:Wearable Scanner
Docking Scanner:
Gently tap the trigger area at the middle of scanner, to enable the
scanner (for reading barcode)
Wearable Scanner:
Press the ring trigger to enable the scanner.
Up Side
Lower Side
The touch sensor area is around middle of the scanner as drawing shown.
Installation
They are Plug &Play USB (HID) devices. When plugged into your Android
OTG devices, it can be recognized as barcode scanner and begin to scan
the barcode. Before using scanner, make sure the smartphone or tablet
is fully charged. Open your APP, they can work as a keyboard input.
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan the “Default” barcode. This will reset the
scanner to its factory defaults. (scan from 1 to 7)
1
5
2
6
3
7
4
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
Keyboard Language (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
USA
(Original setting)
Japan
Denmark
Finland
France
Germany
Italy
Norway
1D Symbologies – 1
ENABLE
CODE 39
DISABLE
ENABLE
CODE 39 Transmit
Start/Stop Character
DISABLE
ENABLE
CODE 39
FULL ASCII
DISABLE
ENABLE
CODE 11
DISABLE
Trigger
Area

2
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
1D Symbologies – 2
ENABLE
MSI
DISABLE
ENABLE
EAN-8
DISABLE
ENABLE
EAN-13
DISABLE
ENABLE
UPC-E
DISABLE
1D Symbologies – 3
ENABLE
UPC-A
DISABLE
ENABLE
Interleaved
25
DISABLE
ENABLE
Matrix
25
DISABLE
ENABLE
Industrial 25
DISABLE
ENABLE
CODE 93
DISABLE
ENABLE
CODABAR
DISABLE
ENABLE
CODE 128
DISABLE
ENABLE
GS1-128
UCC/EAN-128
DISABLE
ENABLE
GS1-Databar
(RSS)
DISABLE
1D Symbologies – 4
ENABLE
GS1-Databar
(RSS-Limited)
DISABLE
ENABLE
GS1-Databar
(RSS-Expand)
DISABLE
ENABLE
ISSN
DISABLE
ENABLE
ISBN
DISABLE
Inter-Keystroke Delay (FOR USB HID Only)
This parameter specifies the delay between emulated keystrokes
No Delay
Short Delay
(5ms)
Medium Delay
(10ms)
Long Delay
(15ms)

Information in this document is subject to change without notice.
R_151117_01