1
Programming Quick Guide
- LS6302J/ LS6302JW/ LS6302K
/ LS6302L / LS6302M
/FS5022J/FS5022JW/FS5022K
/ FS5022L / FS5022M
Installation
Make sure that the scanner has the correct cable to plug in the PC
as below described::
*Note : Please install PL-2303 driver for USB serial
Reset Configuration to Default :
(For USB HID, RS232, USB Serial)
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan the following barcode. This will reset the
scanner to its factory defaults.
Default
Keyboard Language (For USB HID Only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
North American
Standard USB
Keyboard
German
Windows
French
Windows
French Canadian
Windows 95/98
French Canadian
Windows 2000/XP
French Belgian
Windows
Spanish
Windows
Italian
Windows
Swedish
Windows
UK English
Windows
Japanese
Windows (ASCII)
Portuguese-
Brazilian Windows
Redundancy Level
This scanner offers two levels of decode redundancy. Select higher
redundancy levels for decreasing levels of bar code quality. As
redundancy levels increase, the decoder’s aggressiveness decreases.
Select the redundancy level appropriate for the bar code quality.
Redundancy Level 1
barcode must be successfully read twice
before being decoded
Redundancy Level 2
barcode must be successfully read three
times before being decoded:
1D Symbologies -1
ENABLE UPC-A
DISABLE
ENABLE UPC-E DISABLE
ENABLE EAN-8 DISABLE
ENABLE EAN-13
DISABLE
ENABLE Code 128
DISABLE
ENABLE ISBT 128
DISABLE
ENABLE Code 39
DISABLE
ENABLE
Trioptic
Code 39 DISABLE
ENABLE
Code 39
FULL ASCII
DISABLE
