RIOTEC LS6308J User manual

1
Programming Quick Guide
- LS6308J / FS5028J
- LS6308K/ FS5028K
Installation
Make sure that the scanner has the correct cable to plug in the
PC as below described:
*Note : Please install PL-2303 driver for USB serial
Reset Configuration to Default :
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan from A for USB HID or B for RS232 or
USB Serial. This will reset the scanner to its factory defaults.
HID RS232/Serial
A
B
*Note : Please install PL-2303 driver for USB serial
Keyboard Language(For USB HID only)
Scan the appropriate country code as below to program the
keyboard for your country or language. As a general rule, the
following characters are not supported by the scanner for
countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~
United states
of America

German
French

French Mac
Norwegian

Belgian
Spanish

Italian
Swedish

United
Kingdom
Japan

Korean
Finnish Portuguese
1D Symbologies -1
ENABLE
UPC-A/E DISABLE
ENABLE
JAN/EAN DISABLE
ENABLE
Code 128 DISABLE
ENABLE
Code 39 DISABLE
ENABLE
Tri-optic DISABLE
ENABLE
CODE 93 DISABLE
ENABLE
CODE 11 DISABLE

2
1D Symbologies -2
ENABLE Interleaved 25 DISABLE
ENABLE Industrial 25 DISABLE
ENABLE Matrix 25 DISABLE
ENABLE Chinese Pos
t
Matrix 25 DISABLE
ENABLE MSI/Plessey DISABLE
ENABLE UK/Plessey DISABLE
1D Symbologies -3
ENABLE GS1 DataBar DISABLE
ENABLE GS1 DataBar
Limited DISABLE
ENABLE GS1 DataBar
Expanded DISABLE
ENABLE CODABAR DISABLE
ENABLE Telepen DISABLE
2D Symbologies
ENABLE PDF 417 DISABLE
ENABLE Micro
PDF 417 DISABLE
ENABLE Data Matrix DISABLE
ENABLE Maxi code DISABLE
ENABLE Micro
QR CODE DISABLE
ENABLE Aztec DISABLE
 Information in this document is subject to change without notice.
 For more information, please visit:
www.riotec.com.tw R_170322_01