RIOTEC FS5027L User manual

1
*
Programming Quick Guide
-FS5027L
Installation
Make sure that the scanner has the correct cable to plug in the PC as
below described:
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan from A1 to A3 for USB HID This will reset the
scanner to its factory defaults.
A1
A2
A3
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘\ < > ~
USA Japan
Denmark Finland
France UK
Italy Norway
Turkey F Turkey Q
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘\ < > ~
Belgium Spain
Germany
Austria
Russia
Sweden Portugal
1D Symbologies –1
ENABLE EAN-8 DISABLE
ENABLE EAN-13 DISABLE
ENABLE ISSN DISABLE
ENABLE
ISBN DISABLE
ENABLE Codabar DISABLE

2
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
1D Symbologies –2
ENABLE
Matrix
2 of 5 DISABLE
ENABLE Industrial 25 DISABLE
ENABLE Code 39 DISABLE
ENABLE Code 93 DISABLE
1D Symbologies –3
ENABLE
GS1-Databar
(RSS) DISABLE
ENABLE
UPC-E
DISABLE
ENABLE
UPC-A
DISABLE
ENABLE
Interleaved
2 of 5
DISABLE
ENABLE
Code 128
DISABLE
ENABLE
GS1-128
UCC/EAN-128
DISABLE
ENABLE
CODE 11 DISABLE
ENABLE MSI DISABLE
If you want to read the Industrial 2 of 5 (3~5 digital),
please read the below setting code to set the Minimum
Length to 3 digits
1.
2.
3.
4.
5.
6.

3
2D Symbologies
ENABLE
Data
Matrix DISABLE
ENABLE
QR Code DISABLE
ENABLE
Micro
QR Code DISABLE
ENABLE
PDF 417 DISABLE
Inter-Keystroke Delay (For USB HID Only)
This parameter specifies the delay between emulated keystrokes.
No Delay
Short Delay
(20ms)
Long Delay
(40ms)
Remark:
When you have input error, you have to:
1. Try to change other keyboard as default
2. Deactivate spelling correct function & auto prediction
function
3. Change the Keystroke delay as 20ms or 40ms.
lInformation in this document is subject to change without notice.
lFor more information, please visit:
R_160511_03