Rise RXS270 Installation and operating instructions

UPDATED CONTENTS
Rx-R RXS270
Flight Controller
RX Cable
Propellers
Prop adapters with screws
Battery Strap
NOTE: Battery pad is not included
PROP ADAPTER INSTALLATION
The silver prop adapters should be installed on the front left and rear right motors.
The black prop adapters should be installed on the front right and rear left motors.
Please use a threadlocking compound on the screws.
FLIGHT CONTROLLER INSTALLATION
When installing the Flight Controller (FC), be sure to orient the case so the Mini USB
Port is facing the back of the quadcopter. Apply the mounting tape to the bottom of
the flight controller and place it at the center of the frame.
MANUAL ADDENDUM
™
Black
Propeller
Adapter
FRONT
REAR
Black
Propeller
Adapter
Silver
Propeller
Adapter
Flight
Controller
Receiver
(not included)
FPV Transmitter
(not included)
Silver
Propeller
Adapter

The 4 ESC wires need to be plugged into the Output ports 1–4 on the FC. Refer to
the following photo to identify the correct cable for each port. The brown wires for
the plugs should be in the “ - “ column at the edge of the FC.
The 5V power cable should be plugged into Output port 5 or 6 with the brown wire
in the “ - “ column.
RECEIVER
Attach the receiver to the top deck using double sided tape. Route the antennas into
the tubes. Extend the tubes prior to flight.
© 2016 RISE, a Hobbico company.
RISE0270TECH1