Riverside Furniture 26254 User manual

Riverside
Components and Hardware List (for one chair)
FURNITURE
Made in Viet Nam
Page 1 of 2
Mirabelle
Dining Room
Assembly Instructions
Side Stretcher
Steps:
1. Place the Back Assembly (A) on a soft and smooth surface.
2. Attach Chair Seat (B) to the Back Assembly (A) by using the 3-1/4" long Bolt (F) Spring
Washer (I) and Flat Washer (J) into the back corners of the Seat and 1-1/2" long Bolt (H)
Spring Washer (I) and Flat Washer (J) into the middle of the Seat, as shown. Do not fully
tighten Bolts until after next step.
Front Stretcher

Riverside
FURNITURE
Made in Viet Nam
Page 2 of 2
Mirabelle
Dining Room
Assembly Instructions
3: Install the Right & Left Side Stretchers (D) into the Chair Back with the screw holes at the
ends towards the bottom of the legs. Assemble the Front Stretcher (E) between the Front Legs
and assemble the Left and Right Front Legs (C) to the Stretchers and the Chair Seat. Attach
Legs with the 2-1/4" long Bolts (G), and the same washers as before.
4: Set the assembled Chair upright on a flat surface to level chair. Reach underneath the Seat
and tighten all Bolts using the Allen Wrench (L).
5: While pulling the Legs and Stretchers snugly together and using your Phillips Screwdriver,
install the Wood Screws (K) at each end of the Stretchers.