Riverside Furniture 15330 User manual

Components and Hardware List
Made in Viet Nam
Riverside
FURNITURE
email: [email protected]
Modern Gathering
Home Office
Assembly Instructions
Page 1 of 2
#15330
Parquet Writing Desk
Top Legs
A B
Besuretocheckallpackingmaterialcarefullyforsmallparts,whichmayhavecomelooseinsidethecartonduringshipment.
4 pcs.1 pc.
H1
Ø6 x 1.0 x 60mm
Allen Head Bolt
(2-3/8" Long)
8 pcs.
H2
Ø9 x Ø13mm
Allen Head Bolt
8 pcs.
Ø8 x Ø20mm
Flat Washer
8 pcs.
4 x 110mm
Wrench
1 pc.
H7
Ø4 x 0.7 x 30mm
Machine Screw
(1-1/4" Long)
Hardware Knob
4 pcs.2 pcs.
Ø4 x 0.7 x 35mm
Machine Screw
(1-3/8" Long)
H5
2 pcs.
Step 1:
To remove the drawer:
A. Pull the drawers fully open so the black latch is visible in the inside channel of the guides.
B. Release the latches by simultaneously pushing one lever up and the other down.
C. At the same time, pulling the drawer forward until the slides release.
H6
H3 H4
Steps:
1. Remove the drawers and lay them aside. Take note where the two end drawers are
removed from so they can be reinstalled back into the correct location.

H1
H2
H3
H7
Page 2 of 2
A
B
Step 2 & 3:
Step 4 & 5:
To reinstall the drawers, carefully align the channels of the guide and push drawer back into cabinet.
Open and close drawer fully a couple times to verify proper operation.
Steps:
2. Place the Top (A) face down on a soft and smooth surface such as a blanket or carpet.
3. Attach a Leg (B) into each corner of the Desk using the 60mm long Bolts (H1) Spring Washers
(H2) and Flat Washers (H3). Adjust the Leg in the corner if necessary to have the same reveal
on both sides and tighten using the Allen Wrench (H7).
4. After all four Legs are attached, turn the Desk upright and reinstall the drawers.
5. Attach the Drawer Knobs (H6) using the Hardware Screws (H4 & H5) to the Drawer Fronts as
shown, and using your screwdriver.
!WARNING
Pinch Point. Keep
fingers from underneath
drawer front when
releasing.
H4
H6
H5
H6