Riverside Furniture Joelle King Bed User manual

Made in Viet Nam
email: [e-mail]
C-B
20 pcs.
∅1/4-20 x 1" Long
Allen Head Bolt
C-D C-E
106*106*50
Metal
4 pcs.
6/6 Wood Slat
77" Long
F-D F-E
Long Canopy Short Canopy
Headboard Leg Headboard Post
2 pcs. 2 pcs.
2 pcs. 2 pcs.
63084 Canopy Headboard
63085 Canopy Footboard
63076 5/0-6/6 Canopy Bed rails
63087 Canopy top Rails
Joelle
King Bed
Assembly Instructions
∅1/4-20 x 3/4" Long
Allen Head Bolt
C-F
Page 1 of 6

email: [e-mail]
Made in Viet Nam
H-C
H-B
Joelle
King Bed
Assembly Instructions
Detail: A
Detail: B
Headboard Assembly
Page 2 of 6

email: [e-mail]
Made in Viet Nam
Joelle
King Bed
Assembly Instructions
F-C
F-C
F-A
F-G
F-I
Detail: C
Detail: D
Footboard Assembly
Page 3 of 6

email: [e-mail]
Made in Viet Nam
F-B
H-A
H-C
H-B
R-A
R-A
Joelle
King Bed
Assembly Instructions
Steps:
1. Lean the back of the Headboard against the wall where the Bed will be
assembled.
2. Install two All-Thread Bolts (R-B) into the metal threaded inserts installed in the
Headboard Legs and into the metal inserts on the Footboard.
3. Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts on
the Headboard and connect using the Arc Washers (R-D), and Hex Nut (R-C).
Only partially tighten the Nuts until the Footboard has been connected. Repeat
for other Bed Rail.
4. Position and connect the Footboard (F-A) to the other end of the Bed Rails,
attaching as in the previous Steps.
5. Carefully align the Footboard and Headboard to be 'square' with the Side Rails.
Using the Open Wrench (R-E) tighten all Hex Nuts attaching the Side Rails to
the Headboard and Footboard. (See Detail E).
Page 4 of 6

email: [e-mail]
Made in Viet Nam
Joelle
King Bed
Assembly Instructions
6. Attach the eight Slat Support Legs (F-E) to the bottom side of four Wood
Slats (F-D). (See Detail F).
7. Position and attach the Slats to the Bed Rails using the Wood Screws (F-K)
and your Phillips Screwdriver. (See Detail G).
The levelers located at the bottom of the Support Legs can be adjusted if
necessary to support the Slats.
Adjustable leveler
Page 5 of 6

email: [e-mail]
Made in Viet Nam
Joelle
King Bed
Assembly Instructions
C-D
C-D
C-F
C-F
8. Attach the Long Canopy (C-A), Short Canopy (C-B) into the Metal (C-D) by using Allen
Head Bolts (C-E), Tighten all Bolts using the Allen Wrench (C-F). (See Detail H).
9. Carefully place the canopy frame onto the top of the bed posts and assemble by using
hardware as in the previous Steps. (See Detail I).
Page 6 of 6