Riverside Furniture Aberdeen Dining Room 21251 User manual

Table Top
Base Foot
Riverside
Components and Hardware List
email: [email protected]m
FURNITURE
Made in Viet Nam
Page 1 of 2
A
Aberdeen
Dining Room
Assembly Instructions
1 set B
GI
J
Table Top Leaf
M5/16" x 1-3/4"
All-Thread Bolt
5mm Allen
Wrench
5/16" x 19mm
Flat Washer
5/16" Spring
Washer
1 pc.
K
4 pcs.
4 pcs. 16 pcs. 1 pc.
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton
during shipment.
H
M5/16" x 2-3/8"
Allen Head Bolt
8 pcs.
Pedestal
D
F
1 pc.
4 pcs.
E
To prevent possible scratches and damage, this furniture must
be assembled by two people on a soft surface such as a blanket
or carpet.
Step 1: Attach the Lower Bridge Panel (D) on top of the
Pedestal (E) using the 1-3/4" Allen Head Bolts (H), Spring
Washers (K) and Flat Washers (L). Tighten using the Allen
Wrench (M).
H
K
L
Step 1
Leveler
4 pcs.
1 pc.
LM
#21252
Round Dining Table Pedestal
#21251
Round Dining Table-Top
#21253
Round Dining Table Base
Lower Bridge
Panel
M5/16" x 1-3/8"
Allen Head Bolt
E
D
16 pcs.
M
G
I
K
L
F
Step 2
M
Step 2: Assemble the four Base Feet (F) to the Pedestal (E)
using the 2-3/8" Allen Head Bolts (I), Spring Washers (K)
and Flat Washers (L). Tighten using the Allen Wrench
(M). Install the Levelers (G) into the Base Feet, if they are
not already installed.
These three
parts (A, B, D)
are packed in
the 21251 Top
Carton.
The Pedestal (Part E) and all hardware is packed in the 21252 Carton.
The Base Foot (Part F) is the
only part packed in the 21253
Carton.

Riverside
email: [e-mail]
FURNITURE
Made in Viet Nam
Page 2 of 2
Aberdeen
Dining Room
Assembly Instructions
Step 4: To install the Table Top Leaf (B),
reach underneath the sides of the Table
Top and twist the handle of the Locks to
unlock. Pull the two halves of the Table
Top open, place the Leaf in position,
aligning the pins with the holes on the
edges and push the halves back together.
Reach underneath the Table Top and
relock.
The levelers underneath the Base Feet can be
adjusted to compensate for uneven
flooring if needed.
To prevent undue stress on the Dining Table
if it is moved, using two people, always lift
and carry your Dining Table from one
location to another.
J
K
L
Step 3
A
A
B
Step 3: Position and attach the
assembled Pedestal and Base onto
the bottom side of the Table Top
using the 1-3/8" long Bolts (J), and the
same Washers in previous Steps.
Tighten using the Allen Wrench (M).
M