Riverside Furniture Allegro Home Office 44728 User manual

Riverside
FURNITURE
email: [e-mail]
Allegro Home Office
Assembly Instructions
Components and Hardware List
Page 1 of 3
Made in China
728 L Return Desk
Grommet Flat Washer
A B C 3 pcs. 10 pcs. 10 pcs.
Lock Washer Allen Head Bolt
1/ " x 1-1/2"
D
D
D
Be sure to check all packing material carefully for small parts, which may have come
loose inside the carton during shipment.
Step 1: Place the return desk on a clean, soft surface such as a blanket or carpet.
Assemble the four Bun Feet (G) onto the Bottom. Carefully set it upright.
Step 2: Assemble the Back Panel to
the Return Desk, using Allen-Head
Bolts (D Spring Washers (C and
Flat Washers (B . Tighten the Allen
Bolts using the Allen Wrench (D .
Step 3: Remove the middle drawer
from the drawer Pedestal (see
below .
Step 4: Assemble the Top Panel to
the Return Desk, using Allen-Head
Bolts (D Spring Washers (C and
Flat Washers (B . Tighten the Allen
Bolts using the Allen Wrench (D . G
Step 1
Step 3
mm Allen
Wrench
E1 pc.
Key
F1 Set.
Bun Foot
W/ Leveler
G11 pcs.
Wood Shelf
H1 pc. I pcs.
Shelf Pin
J2 pcs.
File rod
10 pcs.
With the drawer fully open, the
drawer slides must be released by
pressing the black lever located in
the slide either up or down,
depending on which slide is being
released. With both levers pressed,
gently pull the drawer until the
slides release.
Carefully reinstall the drawers by
aligning the channels of the
drawer slides and gently pushing
the drawers back into the cabinet.

Riverside
FURNITURE
email: [e-mail]
Allegro Home Office
Assembly Instructions
Components and Hardware List
Page 2 of 3
Made in China
tep 6: Assemble the seven Bun feet onto the
Bottom. Carefully set the Desk back upright.
44728 L Return Desk
G
tep 5: Place the L Desk on a clean, soft surface such
as a blanket or carpet. Remove and discard the shipping
rails attached to the bottom of the Desk.
E
The levelers in
the bottom of the
bun feet can be
adjusted to
compensate for
uneven flooring,
if required.

Step 8: After moving the Main Desk to it's final location in the room,
assemble the return desk to the main desk, using the Allen-Head
olts (D), Spring Washers (C) and Flat Washers ( ). Tighten the
Allen olts using the Allen Wrench (E).
CD
E
CD
A A
Riverside
FURNITURE
email: [e-mail]
Allegro Home Office
Assembly Instructions
Components and Hardware List
Page 3 of 3
Made in China
Step 7: Open the Door and insert Shelf Pins (I) into
holes in side panels at the desired locations. Then
place Wood Shelf (H) on the shelf pins.
44728 L Return Desk
If moving this desk from one
location to another in the room,
always disconnect the two
sections from each other to
prevent undue stress on the
furniture and the connectors.