Riverside Furniture Allegro Home Office Credenza Hutch 44727 User manual

Made in Viet Nam
email: [e-mail]
Allegro Home Office
Assembly Instructions
Components and Hardware List
Page 1 of 2
44727 Credenza Hutch
16 pcs.
A
Shelf Pin
B4 pcs. C
Furniture Tipping Restraint Kit
2 pcs.
Glass Shelf
44726 Computer Credenza
Unscrew to
adjust the
shelf height
B
A
Install the shelf
pins into the
holes and install
the glass shelves
in place.
Tipping Restraint Hardware Kit (C)
(Inside White Plastic Bag)
Both lights in the top of the hutch are controlled
by one touch switch connected to the top hinge of
the right hand door.
WARNING!!!
RISK OF FIRE / INJURY / BURN TO PERSONS /
PROPERTY. KEEP COMBUSTIBLES AWAY FROM
LIGHTING FIXTURE. TURN OFF / UNPLUG TO
CHANGE BULB. DO NOT TOUCH HOT BULB. DO
NOT OPERATE LIGHT IF DAMAGED.
Attach the Hutch to the Credenza using the
mounting plates and screws at the back.
To Wall Oulet

email: [e-mail]
Typical steps to replace bulbs in most common
lighting fixtures that use halogen bulbs.
Page 2 of 2
Before replacing halogen puck light bulb,
unplug power cord from wall outlet to
remove power to fixture.
To replace bulb, twist lens cover counter-clockwise
and lift off cover to remove.
Grasp old bulb and pull straight out of socket.
Install new bulb by inserting pins firmly and fully
back into socket. DO NOT TOUCH NEW BULB
WITH BARE FINGERS.
Please see instructions.
Replace lens cover back on fixture and lock in
position by twisting cover clockwise.
Before replacing halogen task light bulb,
unplug power cord from wall outlet to
remove power to fixture.
Using your Phillips screwdriver, loosen the two
screws on each end of light fixture three to four
turns each.
Slide the glass lens out from underneath brackets on
the ends.
Grasp old bulb and pull straight out of socket.
Install new bulb by inserting pins firmly and fully
back into socket. DO NOT TOUCH NEW BULB
WITH BARE FINGERS.
Please see instructions.
Slide glass lens back in place underneath the
brackets and retighten the four screws.