Riverside Furniture Verona User manual

1 pc.
Queen Panel Footboard
Hardware and Parts packed with the Bed Rails
Panel Queen Bed
Assembly Instructions Made in Viet Nam
Slat Support Leg
4-1/4" long with
leveler
Page 1 of 2
5/0 Wood Slat
61-5/8" long
Ø9 x 1"
Wood Screw
8 pcs.
4 pcs.
8 pcs.
R-B 1 pc. 8 pcs.
5/16-18 Nut 12 mm Open
Wrench
Ø5/16-18 x 4" Long
All-thread Bolt
5/0-6/6 Bed Rails
2 pcs.
F-A F-C F-D
R-A
R-D R-E
ASSEMBLY STEPS:
1. Carefully lean the back of the
Headboard against the wall
where it will be used. Install the
Ø5/16" x 4" Long All-Thread
Bolts (R-E) into the threaded
inserts of the Headboard and
Footboard (See Detail C).
Hardware and Parts packed with the Footboard
5/16" Curved
Washers
R-C
8 pcs.
F-B 4 pcs.
R-E
R-E
Detail: C
Riverside
FURNITURE
email: [email protected]
Light Sienna Finish (#246) or Dark Sienna Finish (#249):
A 5/0 Queen Size Bed can be configured using the 5/0-6/6
Bed Rails and either style of Headboard and either style
of Footboard combination desired.
Panel Bed Shown:
24670 / 24970 -- 4/6-5/0 Panel Headboard
24671 / 24971 -- 5/0 Panel Footboard w/Slats
24672 / 24972 -- 5/0-6/6 Bed Rails
1 pc.
R-F
Ø5 mm
Wrench
Verona

Page 2 of 2
Made in Viet Nam
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
2. Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts installed on the Headboard
and connect using the Curved Washers (R-B) and Nuts (R-C). Only partially tighten the Nuts until the
Footboard has been connected. Repeat for other Bed Rail.
3. Position and connect the Footboard (F-A) to the other end of the Bed Rails, attaching as in the previous
Steps.
4. Carefully align the Footboard to be 'square' with the Headboard. Using the Open Wrench (R-D)
tighten all Hex Nuts attaching the Side Rails to the Headboard and Footboard. (See Detail D).
5. Attach the four Support Legs (F-C) to the bottom side of four Wood Slats (F-B). (See Detail E).
6. Position and attach the Slats to the Bed Rails using the Wood Screws (F-D) and your Phillips
Screwdriver.
The levelers located at the bottom of the Support Legs can be adjusted if necessary to help support the
Slats.
Panel Queen Bed
Assembly Instructions
Bed rail Detail: D
Bed rail
Footboard
Headboard
Detail: E
F-C
F-B
8 pcs.
4 pcs.
R-A
F-D
F-A
Detail: F
R-A
R-C
R-D
leveling
R-B
Riverside
FURNITURE
email: [email protected] Verona