Riverside Furniture Myra User manual

5/0 Queen Storage Bed
Myra Bed Room
Queen Storage Bed
Assembly Instructions
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
M5/16" x 1-3/4 " Long
Allen Head Bolt
8 pcs.
M5/16" Spring
Washer
8 pcs.
M5/16" x 19mm
Flat Washer
8 pcs. 1 pc.
5mm Allen
Wrench
8 pcs. 8 pcs.
Drawer
2 pcs.
Hardware and Parts packed with the Headboard
8 pcs.
Drawer Box
Support Leg
2 pcs.
M5/16"-18 x 3-1/2 "
Long All-Thread Bolt
M5/16" Spring
Washer
M5/16" x 16*2mm
Flat Washer
8 pcs.
9-1/4" long with leveler
Headboard Panel
H-A 1 pc. One Left &
One Right 1 pc.
Headboard Post Headboard Stretcher
1 pc.
Storage Footboard Frame
Bed Rail
2 pcs.
Hardware and Parts packed with the Footboard
Hardware and Parts packed with the Bed Rails
H-B H-C
H-D H-E H-F H-G
F-A F-C F-D
R-A
R-B R-C R-D R-E
5/0 Wood Panel with
blocks 61" x 20-1/4"
Panel Support Leg
13-1/2" long with
leveler
F-E F-F F-G F-H F-I
4 pcs. 4 pcs.
1 pc.
4 pcs. 4 pcs. 4 pcs.
M5/16" Spring
Washer
M5/16" x 19*2mm
Flat Washer
M5/16"-18 x 1-1/2 "
Long Allen Head Bolt
F-J F-K
5mm Allen
Wrench
1 pc.
#8 x 1" Wood
Screw
R-F
Page 1 of 7
R-H 1 pc.
4mm Allen
Wrench
12mm Open
Wrench
5/16-18 x L17 Hex
Nut
F-B
5/0 Wood Slat
61" long
4 pcs.
28 pcs.
R-G
8 pcs.
∅50mm Arc-Washer
59370-59470 4/6-5/0 LOUVER HEADBOARD
59375-59475 5/0 UPH BENCH STORAGE FOOTBOARD
59373-59473 5/0-6/6 BED RAILS

Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
M5/16" -18 x 1-3/4 "
Long Allen Head Bolt
8 pcs.
M5/16" Spring
Washer
8 pcs.
M5/16" x 19*2mm
Flat Washer
8 pcs. 1 pc.
5mm Allen
Wrench
8 pcs. 8 pcs.
Hardware and Parts packed with the Headboard
8 pcs.
M5/16" Spring
Washer
M5/16" x 16*2mm
Flat Washer
8 pcs.
Headboard Panel
H-A 1 pc. One Left &
One Right 1 pc.
Headboard Post Headboard Stretcher
1 pc.
Footboard Frame
Bed Rail
2 pcs.
Hardware and Parts packed with the Footboard
Hardware and Parts packed with the Bed Rails
H-B H-C
H-D H-E H-F H-G
F-A F-B
R-A
R-B R-C R-D R-E
Page 2 of 7
5/0 Queen Bed
M5/16" -18 x 3-1/2 "
Long All-Thread Bolt
5/16-18 x L17 Hex
Nut
Headboard Post
5/0 Wood Slat
61" long
4 pcs.
Slat Support Leg
7-1/2" long with leveler
1 pc.
4mm Allen
Wrench
R-F R-G
4 pcs.
F-C F-D
#8 x 1" Wood
Screw
8 pcs.
Myra Bed Room
Queen Bed
Assembly Instructions
1 pc.
12mm Open
Wrench
R-G
8 pcs.
∅50mm Arc-Washer
59371-59471 5/0 LOUVER FOOTBOARD
59373-59473 5/0-6/6 BED RAILS
59370-59470 4/6-5/0 LOUVER HEADBOARD

Page 3 of 7
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
H-F
H-E
H-D
H-G
H-G
H-D
H-E
H-F
H-C
Detail: B
H-B
H-B
H-A
Detail: A
Myra Bed Room
Queen Bed
Assembly Instructions
ASSEMBLY STEPS :
1. Place the Headboard Panel (H-A) face down on a clean and soft surface.
2. Attach the Left and Right Headboard Posts (H-B) to the back of the Headboard Panel, using
the Flat Washers (H-F), Spring Washers (H-E) and Bolts (H-D). Do not fully tighten until
after next step. (see Detail A).
3. Attach the Back Stretcher (H-C) to the Headboard Posts by using the same Washers and Bolts
as previous step. (See Detail B). Fully Tighten all the bolts with the Allen Wrench (H-G).
Gently lean the back of the assembled Headboard against the wall where the Bed will be
located in the room.

Page 4 of 7
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
Detail: C
To remove the drawer:
A. Pull the drawer fully open so the
black latch is visible in the inside
channel of the guides.
B. Release the latches by
simultaneously pushing one lever up
and the other down.
C. At the same time, pulling the
drawer forward until the slides
release.
F-A
F-B
F-C
F-G F-J
F-C
F-H
F-I
Detail: D
Myra Bed Room
Queen Storage Bed
Assembly Instructions
ASSEMBLY STEPS :
1. Remove both drawers from the Storage Footboard. Refer to the steps above.
2. Place the Storage Footboard (F-A) face down on a clean and soft surface.
3. Attach the Support Legs (F-C) to the storage footboard by using the Flat Washers
(F-I), Spring Washers (F-H) and Bolts (F-G). Tighten with the Allen Wrench (F-J).

Page 5 of 7
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
F-E
F-D
4 pcs.
4 pcs.
Detail: F
F-K
R-B
The Wood Cleat mounted on the back side of the Bed Rails must be mounted
at the upper location for the Storage Bed. If needed, remove the Bolts and
Washers and remount it at the upper position on the Bed Rails.
R-H
Bed rail
R-A
Bed rail
R-A
Storage
Footboard
F-F
4 pcs.
Headboard
R-GR-C
R-E
R-F Detail: E
R-D
Myra Bed Room
Queen Storage Bed
Assembly Instructions
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
4. Install All-Thread Bolts (R-B) into the Headboard (H-A) and the Storage Footboard (F-A) before
Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts on the Headboard and
connect using the Arc Washers (R-F), Flat Washers (R-E), Spring Washers (R-D), and Hex Nut (R-C). Do
not fully tighten the Nuts until the Footboard has been connected. As shown in (Detail E)
5. Carefully align the Storage Footboard and headboard to be 'square' with the Side Rails. Fully tighten all
the hex nut (R-C) by using the open wrench (R-G). As shown in (Detail E).
6. Attach the eight Slat Support Legs (F-E) to the bottom side of four Wood Slats (F-D). (See Detail F).
7. Using one of the Support Panels (F-F) as a gauge, locate and position the four Slats so there is a Slat underneath,
centered at the edge of each Support Panel. Attach using the Wood Screws (F-K).
8. Reinstall the Drawers into the Footboard by aligning the metal channels of the guides and push back
into the Footboard.
Adjustable leveler

Page 6 of 7
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
Detail: F
F-C
F-B
4 pcs.
4 pcs.
Bed rail
R-B
R-A
R-H
The Wood Cleat mounted on the back side of the Bed Rails must be mounted at
the lower location for the Standard Bed. If needed, remove the Bolts and Washers
and remount it at the lower position on the Bed Rails.
Bed rail
R-A Footboard
Headboard
F-D
R-GR-C
R-E
R-F Detail: E
R-D
Myra Bed Room
Queen Bed
Assembly Instructions
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
4. Install All-Thread Bolts (R-B) into the Headboard (H-A) and the Footboard (F-A) before Carefully
position one end of one Bed Rail (R-A) onto the All-thread Bolts on the Headboard and connect using
the Arc Washers (R-F), Flat Washers (R-E), Spring Washers (R-D), and Hex Nut (R-C). Do not fully
tighten the Nuts until the Footboard has been connected. As shown in (Detail E)
5. Carefully align the Footboard and headboard to be 'square' with the Side Rails. Fully tighten all the hex
nut (R-C) by using the open wrench (R-G). As shown in (Detail E).
6. Attach the four Slat Support Legs (F-C) to the bottom side of four Wood Slats (F-B). (See Detail F).
7. Position and attach the Slats to the Bed Rails using the Wood Screws (F-D).
Adjustable leveler

Riverside
email: [email protected]
USE THESE HOLES FOR ATTACHING A QUEEN SIZE (5/0)
METAL BED FRAME
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
CUSTOMER TO PROVIDE 5/16 X 3-1/2" LONG BOLTS, NUTS
& WASHERS TO CONNECT THE METAL BED FRAME
USE THESE HOLES FOR ATTACHING A FULL SIZE (4/6)
METAL BED FRAME
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
CUSTOMER TO PROVIDE 5/16 X 1-1/2" LONG BOLTS, NUTS
& WASHERS TO CONNECT THE METAL BED FRAME
USE THESE HOLES FOR ATTACHING WOOD SIDE RAILS.
ALL HARDWARE IS INCLUDED WITH THE SIDE RAILS
#59370
Queen Louver Headboard
#953-1EK EASTERN
QUEEN / KING RAILS
The Headboard may be used alone
with a Queen or Full Size
Metal Bed Frame
5/0 Queen Storage Bed
59370-59470 -- 4/6-5/0 Louver Headboard
59373-59473 -- 5/0-6/6 Bed Rails
59375-59475 -- 5/0 Uph Bench Storage Footboard
5/0 Queen Standard Bed
59370-59470 -- 4/6-5/0 Louver Headboard
59373-59473 -- 5/0-6/6 Bed Rails
59371-59471 -- 5/0 Louver Footboard with Slats
Page 7 of 7