Riverside Furniture Newburgh Dining Room 37451 User manual

Be sure to check all packing material carefully for small parts, which may have come loose inside
the carton during shipment. Separate, count and check all parts against the Components and
Hardware List above. Failure to use the correct length bolts in the proper locations may result in
an unsafe product and could also cause damage to the parts being assembled.
24 pcs.
5/16" Spring
Washer
D
M5/16" x 1 1/4"
Allen Head Bolt M5/16" x 1 1/2"
Allen Head Bolt
AC B
5mm Allen
Wrench
8 pcs.
1 pc.
F
Riverside
FURNITURE Made in China
Page 1 of 2
G
Newburgh Dining Room
Assembly Instructions
8 pcs.
H
M5/16" x 3"
Allen Head Bolt
8 pcs.
J
I
H
Steps:
1. Position and assemble the Base Foot onto the bottom of the four Posts using the 3 inch long
Allen-Head Bolts (C), Spring Washers (E) and Flat Washers (D). Tighten with the Allen
Wrench (F).
2. Turn the assembled Posts and Base upright. Position the Bridge Panel on top of the Posts
and attach using the 1 1/2" Allen Head Bolts (B), Spring Washers and Flat Washers. Tighten
with the Allen Wrench.
J
I
Post
4pcs.

Riverside
FURNITURE Made in China
Page 2 of 2
Newburgh Dining Room
Assembly Instructions
G
The table can be assembled while upright as shown, or it may be easier to align bolt holes by
assembling upside down as described below.
3. Place the Table Top (G) upside down on a soft surface.
4. Position the assembled Table Base on the bottom side of the Table Top and align the holes
for both parts.
5. Attach together using the 1 1/4" long bolts (A), Spring Washers and Flat Washers. Tighten
with the Allen Wrench.
Using two people, carefully set the assembled table upright and move to the desired location
in the room.
There are levelers located in the bottom of the base and can be adjusted to compensate for
uneven flooring, if necessary.