Riverside Furniture 15338 User manual

Made in Viet Nam
Riverside
FURNITURE
email: [email protected]
Modern Gathering
Dining
Assembly Instructions
Components and Hardware List (for one Stool)
Page 1 of 2
4 pcs.
Ø8 x 1.25 x 85mm
Allen Head Bolt
Ø8 x 1.25 x 50mm
Allen Head Bolt
4 x 110mm
Allen Wrench
1 pc.
H7
1 pc.
H3
Ø8 x 1.25 x 40mm
Allen Head Bolt
#15338
Gathering Ht. Stool
9 pcs.
H4
Ø9 x Ø13mm
Spring Washer
9 pcs.
H5
Ø8 x Ø20mm
Flat Washer
6 pcs.
H6
Ø4 x 50mm
Wood Screw
Back Seat Front Legs
H1 H2
A B C D
E
1 pc. 1 pc.
1 pc. Left
1 pc. Right
1 pc. 4 pcs.
Step 1 & 2:
Side Stretcher
Front Stretcher
Besuretocheckallpackingmaterialcarefullyforsmallparts,whichmayhavecomelooseinsidethecartonduringshipment.
1 pc. Left
1 pc. Right
A
H7
H1
H5
H4
H3
H4 H5
H7
Steps:
1. Place the Back Assembly (A) on a soft and smooth
surface such as a blanket or carpet.
2. Attach Chair Seat (B) to the Back Assembly using
the 85mm (3-3/8") long Bolt (H1) Spring Washer
(H4) and Flat Washer (H5) into the back corners of
the Seat and the 40mm (1-5/8") long Bolt (H3) and
the same Washers into the middle of the Seat, as
shown.Do not fully tighten any Bolts until Step 7.
3. Assemble the Front Stretcher (E) between the Left
and Right Front Legs (C) as shown in Step 3. E
C
Step 3:

Page 2 of 2
Step 4:
A
A
Step 5:
A
4. Assemble the Left and Right Side Stretchers (D)
to the Back Assembly.
5. Place the assembled Front Legs and Front
Stretcher onto the corners of the Chair Seat and
onto the ends of the Side Stretchers.
6. Pull the Legs and Stretchers snug together to
verify they are assembled correctly. Attach using
the 50mm (2") long Allen Head Bolts and the same
Washers as before.
7. Set the assembled Stool upright to level Stool.
Reach underneath and tighten all Bolts using the
Allen Wrench (H7).
8. Using your Phillips Screwdriver, install the Wood
screws into the ends of the Stretchers while
pulling the Stretcher snug to the Leg.
D
Step 6:
H2
H4
H5
H7
H6
Step 7 & 8: