Riverside Furniture Framingham Table User manual

Riverside
FURNITURE
email: [email protected]
Framingham Tables
Assembly Instructions Made in China
Page 1 of 2
12 pcs.12 pcs.
M5
16" x 2" Allen
Head Bolt
M5
16" Flat
Washer
M5
16" Spring
Washer
1 pc.
5mm Allen Wrench
4 pcs. 1 pc.
Top Assembly Leg
2 pcs.
10 pcs. 2 pcs.
M3
4" x 1 2" Wood Plug
Stretcher
1 pc.
1 pc.1 pc.
Caster
Bottom Shelf
2 pcs.
M8 x 30 Wood
Dowel
Open Wrench
Be sure to check all packing material carefully for small parts, which may have come loose
inside the carton during shipment.
Step 1. To prevent possible scratches or damage, assemble the Table upside down on a soft surface
such as a blanket or carpet.
Step 2. Push the WOOD DOWEL (G) into the STRETCHER (J). Attach LEGS (I) to the STRETCHER
using the M 5
16" x 2" ALLEN HEAD BOLTS (A) through SPRING WASHER (C) and FLAT
WASHER (B). Tighten BOLTS using the ALLEN WRENCH (D). Then press The WOOD PLUG
(F) firmly into the hole.
Step 3. Attach the BOTTOM SHELF (K) to the assembled LEGS AND STRETCHER ASSEMBLY
using M 5
16" x 13
8" ALLEN HEAD BOLT (E) through SPRING WASHERS (C) and FLAT WASHERS
(B). Do not fully tighten BOLTS until after next Step.
Step 4. Attach the LEGS AND STRETCHER ASSEMBLY to the TOP (H) using the M 5
16" x 13 8" ALLEN
HEAD BOLT (E) through SPRING WASHER (C) and FLAT WASHERS (B). Tighten all BOLTS
connecting the BOTTOM SHELF and the TOP using the ALLEN WRENCH (D).
Step 5. If the CASTERS (L) will be used, install into the BOTTOM PANEL as shown. Tighten with
the OPEN WRENCH (M).
Step 6. Carefully turn the Table upright .
2 pcs.
M5
16" x 13
8" Allen
Head Bolt

Riverside
FURNITURE
email: [email protected]
Framingham Tables
Assembly Instructions
Page 2 of 2