Riverside Furniture Sophie User manual

Sophie
Queen Bed
Assembly Instructions
10 pcs. 10 pcs. 10 pcs.
2 pcs.
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside Page 1 of 4
50370 4/6-5/0 PANEL HEADBOARD
50371 5/0 PANEL FOOTBOARD
50372 5/0-6/6 BED RAILS (FOR 5/0 BED)
1 pc.
8 pcs.
8 pcs. 8 pcs.

Page 2 of 4
email: [email protected]
FURNITURE
Riverside
It is highly recommended that two people are used to safely
assemble this Bed.
Steps:
1. Lean the back of the Headboard against the wall where the Bed
will be assembled.
2. Attach the Side Rails to the Footboard using the 1" Long Allen
Head Bolts (R-B), Spring Washers (R-D), and Flat Washers (R-E).
(See Detail A). Do not fully tighten Bolts until .
3. Move the assembled Footboard and Rails to the front of the
Headboard. Assemble the end of the Side Rails to the Headboard
using the two 1" Long Bolts, Flat Washers, Spring Washers, and
Hex Nuts (R-F) through the two top holes of the Side Rails, as
shown. (See Detail B). Do not fully tighten bolts.
4. Assemble the Headboard Stretcher (H-B) to the Headboard posts
and Side Rail using four 1-3/4" Long Bolts (R-C) and the same
Washers and Hex Nut as before, through the lower four holes.
5. Carefully align the Footboard to be 'square' with the Headboard.
Using the Open Wrench (R-G) and Allen Wrench (R-H) tighten all
Bolts and Nuts attaching the Side Rails to the Headboard and
Footboard. (See Detail E ).
Made in Viet Nam
Sophie
Queen Bed
Assembly Instructions
Use 1" long Bolts through these two
holes on Headboard when attaching
Side Rails
BED RAIL Use 1-3/4" long Bolts through
these four holes on Headboard,
when attaching Side Rails and
Stretcher, on both sides
HEADBOARD
HEADBOARD STRETCHER
Use these two holes if connecting a
Full-Size Metal Bed Frame
Use these two holes if connecting a
Queen-Size Metal Bed Frame

Page 3 of 4
email: [email protected]
FURNITURE
Riverside
6. Attach the four Slat Support Legs (F-C) to the bottom side of four Wood Slats
(F-B). (See Detail F).
7. Position and attach the Slats to the Bed Rails using the Wood Screws (R-I)
and your Phillips Screwdriver. (See Detail G)
The levelers located at the bottom of the Support Legs can be adjusted if
necessary to support the Slats.
Made in Viet Nam
Sophie
Queen Bed
Assembly Instructions

Riverside
email: [email protected]
Page 4 of 4
5/0 Queen Panel Bed
The Headboard may be used alone
with a Queen or Full Size
Metal Bed Frame
Sophie
Queen Headboard
Assembly Instructions
USE THESE HOLES FOR ATTACHING WOOD SIDE RAILS.
HARDWARE IS INCLUDED WITH THE SIDE RAILS
Use these two holes if connecting a Queen-Size Metal Bed Frame
Use these two holes if connecting a Full-Size Metal Bed Frame
NOTE:
THE BOLTS AND WASHERS THAT ARE USED TO ATTACH
THE HEADBOARD STRETCHER WILL ALSO BE USED WHEN
CONNECTING A METAL BED FRAME TO THE HEADBOARD.