4English
You navigate in this menu with [TUNE -/+] buttons (5/6) , Confirm with the [ENTER]
button (3);
Select Alarm ON, , Frequency of alarm (daily, once etc), Wake up time, Source
(Buzzer/DAB/FM), Volume setting, Duration (15/30/45 etc).
After select Alarm on to confirm all previous operations .
To turn ON or OFF alarm (in stand by mode): In stand by mode, press [EQ/RPT] (10)
button tu turn ON/OFF alarms.
SLEEP: in ON mode, enter MENU mode, SLEEP setting, you can select 15/30/45/60/90
minutes , press [ENTER] button (3) to confirm.
Auto Update: you can choose radio can update Date/time.
Press the [TUNE -/+] buttons (5/6) to select From Any/DAB/FM or no update;
BACKLIGHT: select with [TUNE -/+] button (5/6) BACKLIGHT, press [ENTER] (3) to
enter, select with [TUNE -/+] button (5/6) following info:
DIM LEVEL: you can choose dimmer level. select with [TUNE -/+] button (5/6) desired
level.
On level: indicates the brightness level of the display when the device receives com-
mands.
FACTORY RESET: in SYSTEM SETTINGS, select with [TUNE -/+] button (5/6) YES
to Factory settings.
FM RADIO OPERATION
Select “FM” mode by pressing the [FUNCTION] button (2);
Adjust radio frequency to your desired station as follows:
MANUAL SCAN: Use the [TUNE -/+] buttons (5/6) to fine tune your desired station in
a step of 0.05 MHz or press and hold the [TUNE -/+] buttons (5/6) to scan the next/
previous available station.
AUTO SCAN: Press & Hold [PLAY] button (3) to start automatic scan.
PRESET
The PROGRAMMING operation is the same as that of DAB Preset.
Note: For a better reception, reorient the antenna (13).
CD-MP3 OPERATION
Select “CD” mode by pressing the [FUNCTION] button (2);
Open the CD door (14) and place a CD-MP3 disc with the label up in the CD compart-
ment.
Close the CD door (14). Focus search is performed and playback will start automati-
cally from the first track.
REPEAT
To play a single track continuously, disk continuously or folder (MP3 only) press [EQ/
RPT] button (10), you can select Rep-1, REP-ALL or REP-DIR (MP3 only).
Pressing again [EQ/RPT] button (10), you can select RANDOM function..
PROGRAMMING
You can program tracks for disc play in any order.
Stop the playback by pressing [STOP] (4);
Press [PROG] (12), the display (1) will show “P01” and flash;
Select desired track by using [TUNE -/+] buttons (5/6);
