Rochester Gauges Magnetel Series User manual

Magnetel®Light Module Installation Instructions
ISO 9001:2008 CERTIFIED
DS-1801
The Measure of Excellence
See reverse side for dimensional data, materials of construction, performance, and advice on ho to order.
* Materials and speci ications are subject to change with out notice.
1) nscrew and remove existing cover screws from
Magnetel®4” R3D®Dial
Notes:
• 0023S00031/0023S00032 Light Module is only compatible with the 4” Fluorescent Dial
(5APKS03045 or 5APKS03079)
• 0023S00033 Light Module is compatible with the 4” Standard Silver background Dial
(5ANTS03047)
2) Gently pop out existing cover plate and remove plug
3) If strain relief is required, insert strain relief clip into
-shaped slot in crystal.
Note: Strain relief clip is only required if there is no Remote
Monitoring plug-in module. Relief clip is not needed if Light
Module and Remote Monitoring are utilized simultaneously.
See step 5 where Remote Monitoring Plug-in module is snapped
onto the dial.
Cover Plate
Plug
Relief Clip

DS-1801
The Measure of Excellence
11616 Harry Hines Blvd. •P.O. Box 29242 •Dallas, TX 75229 •[phone] • FAX [phone]
Website http://www.rochestergauges.com • E-mail in [e-mail]
10/02/2017
Magnetel®Light Modual Installation Instructions
4) Twist Cable so jacket is at or above tab edge (see
below) to ensure cable is strain relieved after light
module assembly is snapped onto crystal.
5)Snap Light Module cover onto crystal.
If strain relief clip is
required, ensure Light
Module cable is positioned
in strain relief clip after
snapping closed.
6) Re-insert screws back into cover using torque of 6 in.-lbs
7) Connect wire leads to truck power (typically through trailer light system).
Note: Wires are non-polarity sensitive.
Tab Edge
Light Module and
Remote Monitoring
Plug-in module utilized
simultaneously.