Rohnson R-7528 User manual

Kettle R-7528 Safe touch
EN
1
Instructions Manual
Kettle R-7528 “Safe touch”
Read this booklet thoroughly before using it and save it for future reference

Kettle R-7528 Safe touch
EN
2
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions before using.
2. Before connecting the kettle to the power supply, check that the voltage indicated on the appliance
(underside of the kettle & base) corresponds with the voltage in your home. If this is not the case,
contact your dealer and stop using the kettle.
3. Do not let the cord hang over the edge of a table or counter or touch a hot surface.
4. Do not place on or near a hot gas or electric burner or in a heated oven.
5. Do not operate the appliance without anything in it to avoid damaging the heat elements.
6. Ensure that the kettle is used on a firm and flat surface out of reach of children, this will prevent the
kettle from overturning and avoid damage or injury.
7. To protect against fire, electric shock, or personal injury, do not immerse the cord, electric plugs, or
kettle in water, or other liquids.
8. While water is boiling, or just after the water has been boiled, avoid any contact with steam from the
spout.
9. Always take care to pour boiling water slowly and carefully without tipping the kettle too fast.
10. Be careful of refilling when the kettle is hot.
11. This appliance can be used by children aged 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
12. Children should be supervised to ensure that they do not play with the appliance.
13. Do not touch the hot surface. Use the handle or the button.
14. The attached base can not be used for other than the intended use
15. Extreme caution must be used when moving an appliance containing hot water.
16. The appliance is not a toy. Do not let the children play with it.
17. The kettle is for household use only. Do not use outdoors.
18. The use of accessories, which are not recommended by the appliance manufacturer, may result in
fire, electric shock, or personal injury.
19. Unplug the kettle from the outlet when not in use and before cleaning. Allow the kettle to cool before
putting on or taking off parts, and before cleaning the appliance.
20. To disconnect, turn any control to “off,” then remove the plug from the wall outlet.
21. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent, or a
similarly qualified person in order to avoid any hazard.
22. Do not use the appliance for other than the intended use.
23. The kettle can only use with the stand provided.
24. If the kettle is overfilled, boiling water may spill out.
25. Always ensure the lid is closed and do not lift it while the water is boiling. Scalding may occur if the
lid is removed during the brewing cycles.
26. This appliance is intended to be used in household and similar applications such as:
–Staff kitchen areas in shops, offices, and other working environments;
–Farmhouses;
–By clients in hotels, motels, and other residential-type environments;

Kettle R-7528 Safe touch
EN
3
–Bed and breakfast type environments.
27. Save these instructions.
KNOW YOUR ELECTRIC KETTLE
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean your kettle before
use by boiling the Max capacity of water once and then discarding the water twice. Wipe the surface
with a damp cloth.
NOTE: The max capacity of the kettle is 1.5L.
USING YOUR ELECTRIC KETTLE
1. Place the kettle on a flat surface.
2. To fill the kettle, remove it from the power base and press the lid handle to open it, then fill the kettle
with the desired amount of water and close the lid. The water level must be within the Min and the Max
level. Too little water will cause the kettle to switch off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before plugging in the power outlet.
3. Place the kettle on the power base.
4. Connect the plug to a power outlet. Press the power switch and its indicator will light up, and then the
kettle starts to boil the water. The kettle will switch off automatically and the indicator will turn off once
the water has boiled. If necessary, it will take you 30 seconds to wait before pressing the power switch
again to re-boil the water. You may shut off the power by directly lifting the kettle from the power base at
any moment to stop the boiling process.
NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the kettle will not turn off if
the switch if be constrained or if the lid is opening.
5. Lift the kettle from the power base and then serve the water.

Kettle R-7528 Safe touch
EN
4
NOTE: Operate carefully when pouring the water from your kettle as boiling water may result in scald,
besides, don’t open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be stored on the power
base when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of boil-dry protection will
automatically switch off the power. If this occurs, allow the kettle to cool prior to filling it with cold water
before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it down completely before cleaning.
1. Never immerse the kettle, power cord, or power base in water, or allow moisture to contact these
parts.
2. Wipe the appearance of the body with a damp cloth or cleaner, never use a poisonous cleaner.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle
to prevent gloss loss.
3. When not used or stored, the power cord may be wound under the power base.
REMOVAL OF MINERAL DEPOSITS
The kettle should be periodically descaled as the mineral deposits in tap water may form a scale on the
bottom of the kettle to cause the operation less efficient. You can use the commercially available
descaler and follow the instructions on the package of the descaler. Alternatively, you may follow the
below instructions using white vinegar.
1. Fill the kettle with 3 cups of white vinegar, then add water to the amount so as to cover the bottom of
the kettle completely. Leave the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then filling the kettle with clean water to the maximum position,
boil and then discard the water. Repeat several times until the odor of vinegar has been flushed away.
Any stains remaining inside the spout can be removed by rubbing it with a damp cloth.

Kettle R-7528 Safe touch
EN
5
TECHNICAL SPECIFICATIONS
Rated voltage range
220-240 V
Rated frequency
50-60 Hz
Rated power
1850-2200 W
Capacity
1,5L
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT
IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection center or to a dealer providing this
service.
Disposing of a household appliance separately avoids possible negative consequences for the environment
and health, deriving form inappropriate disposal and enables the constituent materials to be recovered to
obtain significant savings in energy and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out wheeled dustbin.