Rohnson R-437 User manual

JUICE EXTRACTOR
R-437
Instruction Manual
INDOOR HOUSEHOLD USE ONLY

Please read all instructions carefully before using
*Diagram of name and position of main components
1. Pushing bar 2.Transparent cover 3. Juicing net 4. Middle base 5. Handle
6. Residue barrel 7. Main machine 8. Juicer jug
*Performances
1.For the juicer with large diameter, entire apple or pear can be put in for juicing, no
cutting apart needed, easy and quick.
2.Design is fine, simple, and beautiful, with combined structure, easy to operate and
clean.
3.High speed electric motor with overheating protection is adopted, high efficiency,
time saving, energy saving, high service life of the motor.
4.Safety lock unit for switching is specially designed, in order to make sure safety and
reliability in use.

*Attention before using
1.This machine is set with safety unit, when the handle does not fasten the cover or
the cutter seat is not fastened, the motor cannot turn, so as to ensure safety for the
user.
2.When disassembling or assembling the juicer, press the upper of feed port of the
cover with your hand, then force the handle to slide in or out of cover slot.
3.When disassembling juicing net, first remove the cover and residue barrel, then turn
the middle ring up to 30 degrees by holding juicing nozzle with your hand, and take
up, the juicing net will automatically leave the rotor.
4.In order to avoid damage, before using, first check power supply for compliance
with rated voltage .
5.Clean all parts able to disassemble (refer to the section of "maintenance and
cleaning").
6.When assembling, please carefully read the diagram of "name and position of main
components".
7.Please carefully read the "attentions" before using.
*Juicing
1.Before using, please confirm the button switch of the main machine in 0 position, in
this way, in case assembly is not completed, starting the main machine can be
avoided, so unnecessary damage for persons or property avoided.
2.Before juicing, first confirm juicing net and rotor clutched in position, and no hard
contact between juicing net cutter and transparent cover. Put the transparent cover
on, put the handle into the cover slot, then turn on the machine.
3.For using, assemble according to the diagram of "name and position of main
components". Turn on power supply, press switch to let the machine run no-load for
5 sec. Put prepared vegetable or fruit into feed port of the juicer, press with the
pushing bar, evenly, hard and slowly, juice of the vegetable or fruit can be found,
original, fresh, good for health.
4. Note: when pressing food with the pushing bar, force shall be even or indirect,
pressing force shall not be more than 1 kg, no too sudden force, otherwise, juicing
effect will be reduced.
*Operating time
This machine is designed with button switches of O grading, I grading, II grading (O
for stop, I for weak grading, II for strong grading). For juicing, select strong
grading, for operating time, after operating for 1min, stop for 1min, then use again.
After the above operation is performed for three times, stop for 15 min, do not
operate until the motor is cooled, in this way, service life of this machine will be
prolonged; the machine will serve you more efficiently.

*Attentions
1. This machine is unavailable for the weakness, unresponsive or psychopathic person
(including children), unless under the direction or help from the person who have
the responsibility for security. Children should be overseen, so it can be testified
that they are not playing with it.
2. Before using, put this machine on a stable and even table board, operate according
to the above methods.
3. Before juicing, first confirm juicing net and rotor clutched in position, and no hard
contact between juicing net cutter and transparent cover. Put the transparent cover
on, fasten tight the handle, then turn on the machine.
4. Before being used, the motor works in running-in phase, there may be slight
peculiar smell and spark, this is normal, after the motor works for some period, the
above phenomenon will disappear.
5. During juicing, make sure there is not too full juice and residue in the middle seat
and residue cup, if too full, please cut off power supply, clean up, then use again.
6. During using, do not open the cup cover. In case power supply is on, do not put
hand or any ware into the mixing cup or feed port, otherwise, harmful accident may
occur or this machine may be damaged.
7. In order to prolong service life of this machine, over-temperature protective device
is mounted in the motor. If the motor works for a long time or overloaded, when
over warning temperature, power supply will automatically cut off. After the motor
stops, pull out plug of power supply, wait for the motor to cool (about for 30 min),
use again.
8. During operating, please do not leave, never let children operate this machine.
9.When this machine works in mixing, mincing or grinding conditions, no-loaded or
over loaded work is strictly prohibited.
10.After operation, do not pour the food out until pull out the plug of power supply.
11.Cutters are very sharp, in order to avoid danger, when cleaning a cutter, please put
the cutter under water tap for washing, do not wash it with hand.
12.This machine must not be used for others beyond regulated purposes.
13.In case of damaged power supply cord, in order to avoid danger, replacement must
be performed by the manufacturer or its service department or similar professional
persons.
*Maintenance and cleaning
1. This machine shall be often used, so as to keep the motor dry and clean.
2. If not using for a long time, please store this machine at a dry and well-ventilated
place so as to prevent the motor from being damped and going moldy.
3. No washing the main machine. When cleaning, only wipe with wet cloth. Other
components may be washed directly with water, such as pushing bar, cover, middle
seat, residue cup, juice nozzle cover.

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste. It
must be taken to a special local authority differentiated waste collection centre or to a
dealer providing this service. Disposing of a household appliance separately avoids
possible negative consequences for the environment and health, deriving form
inappropriate disposal and enables the constituent materials to be recovered to obtain
significant savings in energy and resources. As a reminder of the need to dispose of
household appliances separately, the product is marked with a crossed-out wheeled
dustbin.