RollEase SafetyHold3 User manual

SafetyHold
TM
3
Instructions for SafetyHold3
Base Guide Insert Spring Screws
©2014 RollEase, Inc. 200 Harvard Avenue, Stamford, CT 06902-6320 USA
Engineered
TM
E
A WCMA 5.2.4 Warning Tag (available from RollEase)
must be fastened to the device prior to shipping.
 e SafetyHold3 must be secured to the clutch or
headrail to make the shade inoperable without
purposeful action of installer.
To properly assemble the bead chain and cord loop tension device,
please  ip this card over for complete step-by-step instructions.
Parts Included
Use appropriate
anchors when
installing.
To order more, phone Customer Service
at 800.552.5100 or 203.964.1573
For additional Product Information,
visit www.rollease.com
03201210000

Slide bead chain or cord
through base entering
through the rounded part
of base following through
the at end.
Once the spring is fully
compressed, turn insert
on an angle and push
through the guide legs.
Turn the insert at and
then release the spring.
For cord, the serrated edge
should face cord. For bead
chain, the smooth edge
should face chain.
Slide base back down the
bead chain or cord and
over the guide.
Pull tension device down
until chain is taut on both
sides. Mark the upper
screw hole, and using
screws provided, install
tension device with upper
hole ” above mark.
Slide the same end of the
bead chain or cord through
the spring following the
base.
Hook the guide through
the end of the bead chain
or cord.
Pull the spring back
down the chain so it is
completely over the guide
and rests on the bottom
legs.
Using thin needle nose
pliers, grasp entire spring
on both sides with the
guide legs pointing up and
squeeze until completely
compressed together.*
* Keep pliers all the way to one side (next to one leg of the guide) to allow room for
insert to be pushed through in Step 6.
1 2 3
456
7 8 9
”