ROOMS TO GO 73051066 User manual

R
Assembly Instructions
Identify all parts packed in the carton against the parts list. Remove all protective
materials. Place parts on a non-abrasive surface to avoid scratching.
Do Not Attempt Assembly If Any Parts Are Missing OrDamaged.
Warning: Please do not use acid or alkaline washing liquid to clean the product.
Assemble the product as shown below, step-by-step.
Part List
NO. SKETCH DESCRIPTION QTY NO. SKETCH DESCRIPTION QTY
A Leg 4 AA
B Fixed Ring 1 BB
C Table Top 1 CC
D Foot Glider 4 DD
Bolt
(M6*20)
Bolt
(M6*25)
Steel Washer
(Φ14*Φ6.5*1.5)
Boltcap 12
Wrench 1
JWUA GLA-5106-2848W
Made in China
1
4
8
12
73051066

STEP 1
Hand Tighten Nut 3-4 Revolutions Only,Do Not Tighten All The Bolts AndNut.
A CC BB DD
B
STEP 2
Hand Tighten Nut 3-4 Revolutions Only,After Attached All The Bolts,Adjust All The
Part At Correct Position,Then Tighten All The Bolt And Nut.Do Not Over Tighten.
DD
AA
CC
A
C
2

STEP 3
Need two people turn the Table right side
at the end of each Table leg until the Table is level with the ground Securely, Your
Table is ready for use.
C
A
D
Need two people turn the Table right side
up.Adjust the pre-
installed foot glider(D)
at the end of each Table leg until the Table is level with the ground Securely, Your
Table is ready for use.
C
B
D
installed foot glider(D)
at the end of each Table leg until the Table is level with the ground Securely, Your
3