Rosehill Wine Cellars 6ft Premier Cru Kit Rack User manual

750ml Half Height Indiv. 6 Col 1
Fasteners
finishing nails to
fasten cross pieces
brad nails if using
pneumatic brad nailer
screws to attach
to other modules
screws for attaching
racks to wall
1
4
1
1
4
1
1
4
#8x1
#8x3
Tips:
1. Using pneumatic brad nailer will make assembly
quicker and easier.
2. Before opening any boxes, if multiple units and
different units have been ordered, please assemble
all boxes by units to ensure that specific unit parts
are not intermixed with other units.
3. It is highly recommended to drill dia pilot
holes on back cross pieces for screws
before attaching to wall.
3
32
#8x3
Assembly Instructions -6Ft-
Tools Needed:
Hammer
Pneumatic Brad Nailer
Power drill
Level
Power miter saw (Preferred)
pilot drill
Nail Set
Wood filler (Optional)
180 grit sand paper (Optional)
3
32
(Preferred)
Feb/22/2013 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack
Countertop: optional

750ml Half Height Indiv. 6 Col 2
Counter top ( optional )
(5 pcs) Cross piece
(1pc)Right end ladder
31
16
36
(5pcs)Middle ladder
31
16
36
(1pc)Left end ladder
31
16
36
Baseboard
Feb/22/2013 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack

750ml Half Height Indiv. 6 Col 3
Topof Rack
1st Cleat
5th Cleat
Step 1
Attaching cross pieces to the BACK
Place the right and left end ladders on the floor making sure
the angled cleats are facing floor. Nail the cross pieces under
the 1st and 5th cleat starting from the bottom. Nail the top
piece flush with top of the ladders.
Step 2
Attaching middle ladders.
Take the middle ladders making sure the angled cleats are facing
front. Place each ladder into cross piece slots and nail from the
back on all five back cross pieces.
First cleat is located
from the bottom of the ladder
1
4
3
Angled cleats facing front
Feb/22/2013 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack

750ml Half Height Indiv. 6 Col 4
Install top cross piece from inside
Redwood counter top ( optional )
baseboard attached
to bottom of rack
1
4
3
Step 3
Attaching FRONT ladders.
Nail the cross piece under the 5th cleat starting from
the bottom. Nail the top cross piece from inside as
shown.
Step 4
Attaching to the wall
Fasten to the wall through the back cross pieces using #8x3“ screws and
using a level to make sure rack is mounted square on the wall. Make sure
back cross piece has ” dia pilot holes drilled before screwing to wall.
For a professional looking job you can use a nail set to indent the nail
heads and wood filler to fill in the nail holes on the front cleats, baseboard
and crown moulding. Give the part that was filled a light sanding with 180
grit sandpaper.
3
32
Feb/22/2013 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack