Rosehill Wine Cellars 6ft Premier Cru Kit Rack User manual

Magnum Rack Single Column 1
Fasteners
•finishing nails to
fasten cross pieces
•brad nails if using
pneumatic brad nailer
•screws to attach
to other modules
•screws for attaching
racks to wall
1
4
1
1
4
1
1
4
#8x1
#8x3
Tips:
1. Using pneumatic brad nailer will make assembly
quicker and easier.
2. Before opening any boxes, if multiple units and
different units have been ordered, please assemble
all boxes by units to ensure that specific unit parts
are not intermixed with other units.
3. It is highly recommended to drill dia pilot
holes on back cross pieces for screws
before attaching to wall.
3
32
#8x3
Assembly Instructions -6Ft-
Tools Needed:
•Hammer
•Pneumatic Brad Nailer
•Power drill
•Level
•Power miter saw (Preferred)
•pilot drill
•Nail Set
•Wood filler (Optional)
•180 grit sand paper (Optional)
3
32
(Preferred)
Apr/23/2012 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack

Magnum Rack Single Column 2
Crown
(9 pcs) Cross piece
(1pc) Left end ladder
3
4
72 (1pc)Right end ladder
3
4
72
Baseboard
Apr/23/2012 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack

Magnum Rack Single Column 3
Top of Rack
1st Cleat
4th Cleat
7th Cleat
9th Cleat
Face this cross piece upwards
Step 1
Attaching cross pieces to the BACK
Place the right and left end ladders on the floor making sure the
angled cleats are facing floor. Nail the cross pieces under the
1st, 4th, 7th and 9th cleat starting from the bottom. Nail the
top piece flush with top of the ladders.
Step 3
Attaching FRONT ladders.
Nail the cross pieces under the 4th, 7th and 9th cleat
starting from the bottom. Nail the top piece flush with
front of the ladders as shown.
Apr/23/2012 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack

Magnum Rack Single Column 4
baseboard attached
to bottom of rack
1
4
3
Crown moulding
attached to top of rack
1
2
1
Apr/23/2012 Toll Free: 1-888-253-6807
www.RosehillWineCellars.com
6ft Premier Cru
Kit Rack
Step 4
Attaching to the wall
Fasten to the wall through the back cross pieces using #8x3 “ screws and
using a level to make sure rack is mounted square on the wall. Make sure
back cross piece has ” dia pilot holes drilled before screwing to wall.
For a professional looking job you can use a nail set to indent the nail
heads and wood filler to fill in the nail holes on the front cleats, baseboard
and crown moulding. Give the part that was filled a light sanding with 180
grit sandpaper.
3
32