Rotec WAVE BED User manual

REMOTE control
MAY 2023
POWER CABLE
POWER CABLE
POWER CONVERTER
REMOTE CONTROL 2X AAA BATTERIES
CONTROL BOX
EMERGENCY LOWERING BATTERY STRAP
SYNC CABLE
RETAINER BAR
16X MOUNTING SCREW
COMPONENT overview
4x CROSSBAR KNOB
2x CROSSBAR
FOOT
HEAD
HEAD
FOOT
4x LEG
SIDERAIL RIGHT
SIDERAIL LEFT
OWNER’S MANUAL QUICKSTART GUIDE
MEMORY POSITION 2 DEFAULT SETTING: ZERO GRAVITY UNDER BED LIGHT ON / OFF
HEAD PLATFORM DOWN
SLEEPING POSITION
MEMORY POSITION 1
DEFAULT SETTING: ANTI-SNORE
2X AAA
FOR FURTHER DETAILS
READ THE OWNER‘S MANUAL.
HEAD PLATFORM UP
FOOT PLATFORM DOWN FOOT PLATFORM UP
COSMO SYDNEY COMFORT QUICK START GUIDE
CONNECTIVITY BOX
AND CABLE
MODEL: WAVE BED BY ROTEC

REMOVE STRAPPING TAPE BEFORE
MOUNTING THE CROSSBARS
INSIDE OF FRAME
INSIDE OF FRAME
01 02 03
The Quick Start Guide is not a substitute for the product documentation. For your own safety, read
the complete product documentation before assembling the Bed Frame and putting it into operation.
!
2x
ASSEMBLY
LAY ALL FRAME ELEMENTS ON THE GROUND, USE LABELS ON SIDE RAILS FOR ORIENTATION. INSERT LEGS AND TURN
UNTIL HAND TIGHT.
CONNECT BOTH CROSSBARS TO THE SIDE RAILS. ENSURE THE THREAD PASSES THROUGH THE
HOLE AT THE END OF THE CROSSBAR. ENSURE THE CROSSBARS ARE ORIENTED CORRECTLY.
DO NOT REMOVE PROTECTIVE MATERIAL
DO NOT REMOVE STRAPPING TAPE
BE CAREFUL NOT TO TRIP OVER CABLES
TIGHTEN THE CROSSBAR KNOBS FIRMLY.
HEAD
FOOT
4x
06 07
PLACE THE PLATFORMS CENTRALLY AND TURN THE SCREWS
UNTIL HAND TIGHT
PLACE THE INNER PLATFORMS NEXT TO THE BASE
PLATFORMS. TURN SCREWS UNTIL HAND TIGHT.
08 ENSURE HEAD AND FOOT PLATFORMS ARE ORIENTED
CORRECTLY. TURN SCREWS UNTIL HAND TIGHT.
09 10
PUSH RETAINER BAR TO CLICK INTO PLACE AND
CONNECT POWER CABLES TO POWER CONVERTER
BEFORE USING YOUR ADJUSTABLE BED
FOR THE FIRST TIME:
Place the mattress on the Bed Frame.
Plug the Power Converter into the mains.
Hold any button to perform reset.
Relax!
2x
TIGHTEN THE CROSSBAR KNOBS FIRMLY.
DO NOT CONNECT THE SYSTEM TO THE
MAINS BEFORE FINISHING ASSEMBLY
05 CONNECT THE CABLES, ENSURE ALL PLUGS ARE ORIENTED CORRECTLY
POWER CONVERTER
4x 4x
FOOT
HEAD
8x
TOP
SIDE
TOP
SIDE
04 LAY THE BASE PLATFORM WITH THE CONTROL BOX ON THE FRAME
AND CONNECT THE CONTROL BOX AS SEEN ON THE NEXT STEP
Plug the power cable into the wall electrical outlet.
Press any button on the remote control to pair it with your base.
DO NOT PLUG THE POWER CABLE INTO THE WALL
ELECTRICAL OUTLET BEFORE FINISHING ASSEMBLY