Rowico STELLA User manual

ASSEMBLY INSTRUCTIONS STELLA CHAIR
Unpack chair body from carton and remove protective foam. Look underneath and unzip underlining to reveal legs
and fittings pack.
Front leg assembly
Important : Insert Front Leg in aperture with T nut facing out and push leg down til the shoulder sits on the frame.
Insert longer of 2 sizes of Hex bolt @75mm with washers through corner block and tighten using hex key provided. 2
bolts per leg. Do not over tighten, but legs should not move at all.
PTO

Rear Leg assembly:- Insert rear curved leg with threaded insert lining up with holes in corner block. Most
importantly use the shorter 60mm hex bolts with washer and tighten as before. Store hex key in underside and zip
up cover. In very dry environments the timbers used will shrink slightly, requiring the hex bolts to be tightened up a
little. Again do not over tighten.