Royal Sovereign HCE-220 User manual

Owner’s Manual
Digital Ceramic Tower Heater
Royal Sovereign International, Inc.
HCE-220
Please read and retain these instructions.
For more information, please go to www.royalsovereign.com

Thank you for purchasing the Royal Sovereign Digital Ceramic Tower Heater, HCE-
220. This manual will provide you with safetyinformation, instructions for optimal
use, and proper care and maintenance for your product. Please read this manual
carefully before operating.
CONTENTS
2Read & Fully Understand This Owner’s Manual Before Using This Machine.

3
When using this appliance follow these safety precautions to reduce risk of fire, electric shock, or injury.
SAFETY INSTRUCTIONS
WARNING
Electrical
Check to ensure that the electrical service being used is adequate for your model. The electrical rating of your new
heater is defined on the serial sticker on the unit. Please refer to the rating when checking electrical requirements
to ensure they meet the electrical codes of your location.
1. Do not use this appliance if it malfunctions or is dropped or damaged in any manner.
2. Do not use outdoors. Do not place on or near a hot gas, electric burner, a microwave, or a heated oven.
3. Do not place the cord, plug, or appliance in water or other liquids.
4. The wrong use conflicting with the safeguards voids the customer of the right for warranty service.
5. Do not modify any part of this product.
6. Do not insert any objects into the product or block the airflow in any way.
7. Ensure that the power supply you use has an appropriate voltage rating.
8. If the electrical outlet you intend to use is not adequately grounded or protected by a time delay fuse or circuit
breaker, you should have a qualified electrician install the proper outlet.
9. Do not use this unit with any extension cords or adapter plugs.
10. Do not use this product through other special programs, timers, or other devices.
11. If the cord or plug is damaged in any way, please call the Royal Sovereign Service Department.
12. Turn the unit off and unplug before cleaning the heater or when the heater will not be used for an extended
time period.
13. When overheating should occur the built-in overheating safety device will shut the appliance off.
Operational
1. Do not block air outlets with any obstacles.
2. Do not insert any objects into the heater.
3. Do not let water on the housing or control panel.
4. Do not place heavy items or sit on the heater.
5. Never pull or damage the power cord in any way.
6. Don’t let your children use the appliance.
7. The repair of the appliance must be performed by a professional. Mistakes in repair are dangerous and can
bring great hazard to the user.

PRODUCT VIEW
4
1. ON/OFF Switch
2. Filter
3. Power Cable
4. LED Display
5. Ventilation
6. Base
7. Remote Controller
1.
2.
3.
4.
5.
6.
7.

PRODUCT OPERATION
5
Using the Heater
•Use the ON/OFF switch on the rear of the heater to power the unit into standby mode.
•Press the “POWER” button and the heater will switch out of standby mode. The LED display will
show the room temperature. The heater will begin to heat up to the preset temperature of 77°F.
NOTE: If the room temperature is 2°F higher than the preset temperature, then only the fan will
operate. The heater will switch back on again once the room temperature drops 2°to 3°F.
•If the heater is not operated for 3 seconds, the LED display will show the room temperature.
•The heater will cycle on and off to maintain the preset temperature. This is not a fault with the
appliance.
•To set the heating power, or to use the fan-only mode, press the “MODE” button to cycle through
low heat, high heat, or fan-only settings.
•To set the temperature, press the “TEMP” button to increase to the desired temperature. The LED
display will show the set temperature for 3 seconds.
•Once the room reaches the set temperature, the heater will cycle on and off to maintain this
temperature.
•To set the timer, press the “TIMER” button until the desired time has been reached. The LED
display will show for up to 3 seconds, then revert to displaying the room temperature.