Royal Prince User manual

OWNER'S MANUAL
Operating and Servicing Instructions
Please read these
instructions
carefully before
using your
hand vacuum.
Let us help you
put your vacuum
together or answer
any questions, call
1-800-321-1134.

This information has been compiled by the Vacuum Cleaner Manufacturer'sAssociation
working with government and private sources, concerned with product safety. These
basic guidelines are for your protection and convenience.
.THIS VACUUM IS INTENDED FOR HOUSEHOLD USE ONLY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When you use an appliance, basic precautionsshould always be followed, including the
following:
READ ALL INSTRUCTIONS BEFORE YOU USE THE APPLIANCE.
ALWAYS FOLLOW THESE SAFETY INSTRUCTIONS.
WARNING: TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK OR INJURY:
Look on your vacuum cleaner and follow all
label and marking instructions.
Do not let children play with the vacuum
cleaner. Watch closely when the vacuum
cleaner is used by or near children.
Do nottouch the plug or the vacuum cleaner
with wet hands.
Unplug the vacuum cleaner if you leave the
room. Unplug it when it is not in use and
before you service it.
Turn all controls to "OFF" before unplugging
the vacuum cleaner.
Do not pull on the cord to unplug the vac-
uum cleaner. Grasp the plug instead.
Do not use the power cord to pull or carry
the vacuum cleaner. Do not use the powercord
as a handle. Do not shut any door on the cord
or pull the cord around sharp edges or cor-
ners. Keep the cord away from heated sur-
faces. Do not run the vacuum cleaner over the
cord.
Do not use vacuum cleaner with a damaged
cord or plug. Do not use vacuum cleaner if
working improperly, dropped, damaged, left
outdoors or dropped in water. First, send to
service center for check and repair.
Always turn off the vacuum cleaner before
connecting or removing hose.
Do not use an extension cord with this
cleaner.
Electric shock could occur if used outdoors
or on wet surfaces.
Keep end of hose, wands and other openings
away from your face and body. Keep your
hands, feet, hair and clothing away from mov-
ing parts.
Only use attachments and hoses recom-
mended by the manufacturer. Use the vacuum
cleaner only as stated in this manual.
Do not pick up anything that is hot, smoking
or burning. Do not pick up cigarettes, hot
ashes or matches.
Do not put any object into the vacuum
cleaner vent or other openings. Do notturnthe
vacuum cleaner on if something is blocking an
opening. Keep vents free of things that slow
air flow, such as dust, lint and hair.
Do not use the vacuum cleaner without
dustbag or filters in place.
Be most careful when vacuum cleaning on
stairs.
Do not use the vacuum cleaner to pick up
flammable or combustible liquids or fumes,
such as gasoline, or use in areas where they
may be present.
o Store the vacuum cleaner indoors. Put the
vacuum cleaner away after use to prevent
tripping accidents.
For grounded model: 3-501, connect to a
properly grounded outlet only. See Grounding
Instructions.
Approved by the Vacuum Cleaners Manufacturers Association Executive Committee, April 29, 1987.
2

WARNING:
"To reducethe risk of electric shock, this appliance has a polarized plug (one blade is wider than
the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper
outlet. Do not change the plug in any way."
GROUNDING INSTRUCTIONS
(only for 3-wire models, those that include 2 blades and 1 grounding pin)
This appliance must be grounded. If it should malfunction or breakdown, grounding provides a
path of least resistance for electric current to reducethe risk of electric shock. This appliance is
equipped with a cord having an equipment-grounding conductor and grounding plug. The plug
must be plugged into an appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
GROUNDED
i,,
/
GROUNDING
PIN
-GROUNDING
OUTLET BOX
DANGER - Im~ro~erconnection of the eouioment-orounclinoconductor can result in
a risk of electric shock. ~heck'witha qualified electrician or service person if you are in doubt as
to whether the outlet is properly grounded. Do not modifythe plug provided with the appliance
-
if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
This appliance is for use on a nominal 120-volt circuit and has a grounding plug that looks likethe
plug illustrated in sketch. Make sure that the appliance is connectedtoan outlet having the same
configurations as the plug. No adapter should be used with this appliance.
SAFETY PRECAUTIONS
WARNING:
1. ELECTRIC SHOCK COULD
OCCUR IF USED OUTDOORS
OR ON WET SURFACES.
2. USING IMPROPER VOLTAGE
MAY RESULT IN DAMAGE TO
THE MOTOR AND POSSIBLE
INJURY TO THE USER. PROPER
VOLTAGE IS LISTEDON CLEANER
PLATE. THE ROYAL PRINCE
OPERATES ON 120 VOLTS A.C.
60 CYCLES POWER.
3. DO NOT OPERATE THIS UNIT
NEAR FLAMMABLE GASES OR
LIQUIDS. TO PREVENT FIRE, DO
NOT PICK UPHOT OBJECTSSUCH
AS CIGARETTE BUTTS, ETC.

This vacuum cleaner will operate best
when serviced with genuine parts. To
besurethat you receivegenuine parts
and service at fair prices, have your
cleaner serviced at anAuthorized Roy-
al DealerorseeyourYellow Pagesfor a
dealer near you.
Should you experience any difficulties
in operating this vacuum cleaner, re-
port it immediatelyto the Dealer from
whom it was purchased. Costs of any
transportation toandfrom any place
of
repairareto bepaid bythe owner. The
serviceparts usedinthis unit are easily
replacedandreadilyavailablefrom your
Authorized Royal Dealer or see your
Yellow Pages for a dealer near you.
You have purchased the finest hand
vacuum cleaner available. This mini-
cleanerwith revolvingbrushaction has
most features found only on upright
cleaners.
Followthe instructions enclosed and it
will give you years of efficient service.
NOTE:
REGISTER YOUR CLEANER
TO VALIDATE WARRANTY.

OPERATING INSTRUCTIONS
A. BELT INSTALLATION AND REMOVAL
NOTE:
THE UNIT MUST NOT BE PLUGGED IN
WHEN INSTALLING OR REMOVING THE BELT.
1. Removethe plug on the face
of the cleaner.
NOTE:
PLUG MUST BE ON WHEN
ATTACHMENTS ARE NOT
IN USE.
3. Center and raise the belt with
your left hand as
shown. Using your right hand,
dip the belt lifter in and hook
the belt aroundthe lip of the
belt lifter. Slip the belt onto the
motor shaft
untilthe belt lifter base meets
the shaft.

4. To insure proper belt place-
ment, gently turn belt lifter
clockwise and remove.
Make sure belt is pushed
back on shaft.
5. Pictorial of belt installed prop-
erly. (right side of beltshould
be closest to you).
NOTE:
THE BELT WILL
COME OFF IT NOT
INSTALLED PROPERLY.
6. To removethe belt, hold belt
lifter as shown in photo
2.
Hookthe belt on the right
side of the motor shaft,
turn counterclockwiseand
pull the belt towards you
to release.
BELT
STYLE: 1

B. BAG REMOVAL AND INSTALLATION
NOTE:
UNPLUG CLEANER WHEN
REMOVINGAND INSTALLING BAG.
1. Grasp metalbagringas shown.
Twist to the left to remove.
NOTE:
KEEP BAG OPENINGS
POINTEDTOWARDS
CEILING TO AVOID
SPILLING DIRT.
2. Empty bag in trash receptacle
(no inner liners are required).
3. To replace bag, place metal
bag ring, with !'top" label
facing
up, against the motor
housing as shown. Twist to
the right for secure fit.
NOTE:
BE SURE METAL PIN ON
MOTOR HOUSING AND EYELET
ON METAL BAG RING ARE
LOCKED TOGETHER.

C. ATTACHMENT INSTALLATION
1. Removethe plug and belt, as
described in Section
A.
NOTE:
THE BELT MUST BE
REMOVED FOR
ATTACHMENT USE.
2. Depressspring clip on hose
(as shown). Insert hose into
cavity.
NOTE:
SPRING CLIP MUST LINE UP
WITH GROOVE AT BOTTOM
OF THE CAVITY OPENING.
Pull gently on hoseto insure
a secure fit. When removing
hose, depress spring clip
and pull hose up and out
gently.
Hose attachment is in place
and ready for use. Crevice
tool, extensionwand, and
dusting brush slip easily onto
hose end.

D. PAPER BAG INSTALLATION I F";",: H I
You now have the option to use convenient disposable inserts on your
Prince hand cleaner. It's easy, convenient, and sanitary. Additional paper
inserts can be purchasedat participating dealers or by completing the
HANDY QUICK PARTS MAILER provided. (Part No. 3-050247-001)
2. Drop paper bag into cloth
dust bag. Plastic rim should
lie flat against rubber seal.
3. To replace bag, place metal
bag ring against the motor
housing as shown. Twist to
the right for secure fit.
NOTE:
NOTE: BE SURE METAL PIN ON
KEEP BAG OPENING POINTED MOTOR HOUSINGAND
UPWARD TO AVOID EYELET ON METAL BAG RING
SPILLING DIRT. ARE LOCKED TOGETHER.

E. SHOULDER STRAP INSTALLATION
(strap included with certain models: Available as optional
accessoryto all models
- part no. 3-503600-601)
1. Placethe shortest free-hanging
ends of the shoulder strap, with
snaps, aroundthe handle. The
single clasp should be resting on
top of the handle.
2. Pullthe free-hangingend which
has two snaps on it through the
loop above the handle.
3. Press the first connecting snap
over the mating snap below. The
strap should now befirmly
attached aroundthe handle.
(disregard the second snap on
the free-hanging end. This mat-
ing snap is for use with a differ-
ent model).
4. Smooth out the strap so it is not
twisted.
5. Now placethe longestfree-
hanging end of the shoulder
strap with snaps around the noz-
zle. It should be placed under
and behind the nozzle and con-
tinue up in front of the handle
where the second connecting
snap will press over the mating
snap below. Be sure the clasps
are snapped tightly together. (Dis-
regard the first connecting snap
on the free-hanging end; this
connecting snap is for use with a
different model'.)
6. The strap should be tight around
both the handleand the nozzle.

F. TO REPLACE BELT OR TO ADJUST BRUSH FOR WEAR
Your revolvingbrush has three settingsto compensatefor bristlewear.*
After considerable use, when the Royal Princestops picking up threads
and lint, you should make your first brush adjustment. This unique revolv-
ing brushfeature is designed to give long brush life.
If your belt fails to drive brush, it needsto be replaced.
1. Removethe grey plug and belt, as
described in Section
A.
2.
To remove metal nozzle guard,
placethumb under metal tab as
shown. Push against tab until
nozzle guard comes free from
cleaner. Grasp belt and brush
assembly in the center of the
wooden brush roll. Pull straight
out.
Replace belt and or brush,
if
necessary, at this time.
3. When the brush has become
slightlyworn or where heavy
brushing is desired, replace brush
in holders with number
"2" visible
on caps at end of brush (as
shown). For further brush wear,
move brush rollto position
"3".
NOTE:
ARROWS ON BRUSH ROLL
AND METAL NOZZLE GUARD
MUST BE POINTING IN
THE SAME DIRECTION.
THIS ASSURES PROPER
BRUSH ROTATION.
4. When installing a new brush,
number "1" should be visible on
caps at end of brush.
*not available on all models.

G. STORAGE OF YOUR ROYAL PRINCE
You can store your Royal Prince in the closet, laundry room, or any other
convenient location.
,HANG WANDS HERE
1. Placewall mounting bracket 2. Hang cleaner and attachmentsas
against wall as shown. Use screws
' shown.
provided to mount bracket.
Now that you have a
meet the rest of the family.
01994 Royal Appliance Mfg. Co
all rights reserved
ROYAL APPLIANCE MFG. CO.
650 Alpha Drive
Cleveland, Ohio 44143-2172
1-800-321-1134