RS 202-010 User manual

Copyholder with Clamp
Stock No. 202-010
1. Lineguide can be used on left or right
side. Slide down from top of copyholder,
engaging tabs of lineguide holder with
track of copyholder.
2. Lineguide functions:
A. Pivot Action - Depress knob on back
side of lineguide holder until fully
forward to stop. Use other hand to
gently flip lineguide down to horizontal
position and release pressure on knob.
Reverse steps to pivot lineguide up to
vertical position.
B. Paper Loading - Depress knob as in
step "A" so lineguide "lifts" off copy-
holder. Load paper and release knob.
3. Adjustable Arm: Adjusts to hold letter/
A4 or legal size paper. Factory
assembled in letter/A4 position. For legal
position, grasp paper clip and gently pull
upward until arm locks in place.

4. Paper Clip: To insert paper, press on
back of paper clip, then release after
loading.
Assembly Instructions
1. Tighten CLAMP firmly to table edge.
Insert ARM in CLAMP. Insert COPY-
HOLDER in ARM as shown. Adjust to
desired position and tighten knobs.
Adjust ARM rotation at point A.
2. Adjust COPYHOLDER rotation at point B.
A
Clamp
Arm
Copyholder
B
RS Components Issued July 1992 9069