RSI Systems Furniture SCULPT User manual

USER GUIDE
SCULPT
TABLE LEG

2 |
FEATURES
• BIFMA tested and approved
• Ten-year warranty
• Easy assembly
• Multiple color options
PRODUCT OVERVIEW

| 3
Parts Diagram 4
30" T-Leg 4
Safety Information 5
Assembly Instructions 6-7
TABLE OF CONTENTS
STANDARDS & CERTIFICATIONS
Meets 2014 BIFMA standards.
WARRANTY
Contact your sales representative for warranty information.
CUSTOMER SERVICE
If you have any problems with
your table base, please contact
our service department.

4 |
PARTS
1. Mounting Plate
2. Column
3. Foot
4. Glides
30"T-LEG
PARTS DIAGRAM
1
2
3
4
PARTS DIAGRAM

| 5
SAFETY
INFORMATION
IMPORTANT SAFETY INSTRUCTIONS Save these instructions.
INSTALL ONLY APPROVED WORK SURFACES
This table system does not include a work surface (desktop). Maximum load for table is 200 lb, including work
surface. Maximum desktop dimensions are 30"x72". If you are unsure if your preferred work surface meets
specications, contact customer service.
DO NOT OVERLOAD DESK
To prevent table from tipping or collapsing, make sure the desk frame is not overloaded by the weight
of tabletop and objects on table. Evenly distribute load; excess loads near edges can reduce stability
and cause table to tip over.
• Do not exceed maximum load (including weight of desktop) of 200 lb (91Kg)
• Do not exceed edge load of 25 lb when positioning monitors or mounting accessories
• Do not sit or stand on table
USE CARE WHEN MOVING TABLE
• Remove all objects and mounted accessories from the table before moving
• Clear objects and equipment from table before rolling to reduce the risk of tipping over
SAFETY INFORMATION

6 |
ASSEMBLY
INSTRUCTIONS
INSTALL COLUMN ASSEMBLY TO THE TABLE TOP
Use the chart below to locate the position of the pilot holes on the table top:
ASSEMBLY INSTRUCTIONS
The assembly of the table frame to be made in accordance with this manual.
Changes to the table frame or improper use may affect the safety, function, and life of your product.
This manual applies to the following table legs: 30"T-Leg
1
LEG
CONFIGURATION
FRONT CORNER
HOLE DEPTH
LOCATION (X)
30 in T-Leg 1.5 in
FRONT CORNER
HOLE WIDTH
LOCATION (Y)
2.5 in
X
Center Line of Table Top
Y
X
Y

| 7
Mark the locations of the pilot holes. Drill the pilot holes to the size recommended by the table top
manufacturer. Install the screws through the mounting plate into the table top.
NOTE: The holes in the mounting plate are .280 in
If you have any difculty assembling this unit, or need to order replacement parts, please contact
our Customer Service department. Use the parts diagram on page 4 as a reference.
ASSEMBLY INSTRUCTIONS
5in
2.5in
2.5in
5in

SCULPT
USER GUIDE