RTA Techni Mobili RTA-3839SU User manual

Cable Tie

#1 Insert the cable coming from the motor on leg (1) into the Power Box (11)
in its respective input terminal.
#2 Insert the cable coming from the Control panel (10) into the Power Box (11)
in its respective input terminal.
#3 Insert the Power Cable (12) into the respective terminal of Power Box (11).
#4 Insert the Power Cable (12) into a power outlet.
#5 Use the Cable Ties (13) to hold and keep the cables organized under the
Desk Top (9).
#5

Height unit switch:
“CM”:
Press bottons “1”, “2” and “M” together for about 5 seconds until the display
flashes. Then press botton “1” for about 5 seconds until display “C”.
“Inch”:
Press bottons “1”, “2” and “M” together for about 5 seconds until the display
flashes. Then press botton “2” for about 5 seconds until display “E”.

- DO NOT EXPOSE THE SURFACES TO DIRECT SUNLIGHT OR EXTREME
ENVIRONMENTAL CONDITIONS. ANY DAMAGE RESULTING FROM SUCH
EXPOSURE IS NOT COVERED BY THE PRODUCT’S WARRANTY.
- THE PREFERABLE METHOD TO CLEAN THE SURFACES IS TO WIPE THEM
USING A SOFT CLOTH DAMPENED WITH A SOLUTION SOAP AND WATER,
THEN DRY WITH A CLEAN TOWEL.
- UNPLUG THE UNIT FROM THE POWER SOURCE BEFORE CLEANING IT.
- BE CAREFUL WHEN CLEANING AROUND THE MOTOR, POWER BOX AND
HANDSET; DO NOT ALLOW THESE ELECTRICAL COMPONENTS TO BECOME
IN CONTACT WITH WATER AND KEEP AWAY FROM MOISTURE.
- DO NOT SPRAY SOLVENTS OR CLEANING AGENTS DIRECTLY OVER THE
SURFACES, STRUCTURAL TUBES OR METAL PARTS.
- DO NOT LEAN, SEAT OR STAND OVER THE UNIT.
- DO NOT ALLOW CHILDREN TO PLAY OVER/UNDER THE UNIT, NOR ALLOW
THEM TO OPERATE THE UNIT WITHOUT THE SUPERVISION OF AN ADULT.
- BEFORE MOVING OR TRANSPORTING THE UNIT, MAKE SURE THAT:
ALL HEAVY OBJECTS OR THAT MIGHT FELL OFF ARE REMOVED FROM
THE UNIT.
THE UNIT MUST BE HANDLED BY AT LEAST 2 PERSONS.
WHEN LIFTING THE UNIT, USE BOTH OF YOUR HANDS, AND BEND YOUR
KNEES. REMEMBER TO ALWAYS LIFT WITH YOUR LEGS, NOT YOUR BACK.
IN CASE OF DAMAGE TO ANY PARTS, NOTIFY THE VENDOR AS SOON AS
POSSIBLE.