Ruijie Networks RG-ES126S User manual

RG-ES126S
交换机快速安装指南
Switch Quick Installation Guide

锐捷以太网交换机快速安装指南
Ruijie Ethernet Switch Installation
Quick Start
设备安装
Install the switch
安装前准备
Preparing for installation
安装到桌面：防静电手套（或手环）
Mounting on the desktop: ESD bracelet or gloves
安装到 19 英寸标准机架：防静电手套（或手环）、螺丝刀、螺钉
Mounting to a standard 19-inch rack: ESD bracelet or gloves, screwdriver, screws
安装到桌面
Mounting on the desktop
将脚垫粘贴在机壳底面四角对应的凹槽中，然后将交换机正面朝上放置于足够大且干净平稳
的桌面上。
Paste the footpad stickers to the corresponding four recesses on the bottom of the switch.
Then turn it upside down and place it on a big enough, clean, stable and flat desktop.
安装到 19 英寸标准机架
Mounting to a standard 19-inch rack
1. 检查机架的接地与平稳性。
Ensure that the rack is stable and level, and is properly grounded.

2. 用包装盒内的螺钉将两个 L型支架分别固定到交换机的两侧。
Fix the 2 L-shaped brackets to both sides of the switch with the included screws.
3. 将交换机放置于机架内的适当位置，用螺钉（需自备）将 L型支架固定到机架两侧的
导槽上，确保交换机平稳地安装到机架上。
Mount the switch at a proper height on the rack and fix the L-shaped brackets to the
rack with the screws (not included). Ensure that the switch is stable on the rack.

设备连接
Connect the switch
- 本交换机支持端口自动翻转（Auto MDI/MDIX），用网线连接交换机与对端以太网设备时，使用直连线
或交叉线均可。
Tips
- This switch supports auto MDI/MDIX, so both a straight cable and a crossover cable can be used to
connect the switch to Ethernet devices.
警告
此为 A级产品，在生活环境中，该产品可能会造成无
线电干扰，在这种情况下，可能需要用户对干扰采
取切实可行的措施。

请参考下表检查设备连接是否正确或调节交换机工作模式。
Please check whether the switch is connected properly or adjust the operating mode of
the switch according to the following table.
指示灯/开关
说明
PWR
长亮：交换机通电正常。
熄灭：交换机未通电或通电异常。
1~24、25/25F、26/26F
长亮：端口已连接。
闪烁：端口正在传输数据。
熄灭：端口未连接，或连接异常。
工作模式拨码开关。
标准模式：默认模式。此模式下，交换机为普通非网管型交换机，
所有端口之间可以相互通信。
流控关闭：此模式下，交换机关闭所有端口流控，以满足各种复
杂环境的“网络克隆”需求。
端口隔离：此模式下，1~24 号端口不能互相通信，但都能与 25、
25F、26 和26F 号端口通信。可以隔离 DHCP 广播，减少广播
风暴。
LED indicator/Toggle
Description
PWR
Solid on: The switch is powered on properly.
Off: The switch is not powered on, or not powered on properly.
1 to 24, 25/25F, 26/26F
Solid on: The corresponding port is connected to a device.
Blinking: Data is being transmitted over the corresponding port.
Off: The corresponding port is not connected or is not connected properly.
Warning
This is a ClassA product. In a domestic environment, this
product may cause radio interference, in which case the
user may be required to take adequate measures.

LED indicator/Toggle
Description
Toggle for switching operating modes:
Standard Mode: It is the default operating mode. In this mode,
the switch functions as a common unmanaged switch, and all
ports of the switch can communicate with each other.
Flow Control-OFF: In this mode, the switch disables the flow
control function for all ports to meet the demand of computer
network clone in various environments.
Port Isolation: In this mode, ports 1 to 24 cannot communicate
with each other, but can communicate with ports 25, 25F, 26
and 26F respectively, which helps isolate DHCP broadcast and
reduce broadcast storm.
规格参数
Specifications
产品型号
RG-ES126S
端口
10/100Mbps RJ45 端
口
24
10/100/1000Mbps
RJ45 端口
2
SFP 端口
2
25F 与25 复用，且 25F 端口优先；26F 与26 复用，且 26F 端
口优先。
工作模式
支持三种模式切换：标准模式、流控关闭、端口隔离
性能
交换模式
存储转发
MAC 地址表
16K
MAC 地址学习
自动学习、自动老化
外形尺寸（长×宽×高）
440mm×240mm×44mm
电源输入
100~240V AC，50/60Hz，0.4A
防雷
RJ45 端口
共模：4kV
电源
共模：6kV；差模：6kV
工作环境
工作温度：0℃～45℃
工作湿度：（10～90）%RH，无凝结
存储环境
存储温度：-40℃～70℃
存储湿度：（5～90）%RH，无凝结

产品型号
RG-ES126S
网络介质
以太网：3类或以上 UTP/STP
快速以太网：5类或以上 UTP/STP
千兆以太网：建议使用超 5类或 6类UTP/STP
1000Base-SX：MMF（多模光纤）
1000Base-LX：MMF（多模光纤）或 SMF（单模光纤）
网络标准
IEEE 802.3、IEEE 802.3u、IEEE 802.3ab、IEEE 802.3x
EMC
GB9254-2008
安规
GB4943-2011
Product model
RG-ES126S
Port
Number of 10/100
Mbps RJ45 port
24
Number of 10/100/1000
Mbps RJ45 port
2
SFP port
2
Port 25F and port 25 compose a combo port, and port 25F
owns a higher priority; port 26F and port 26 compose a combo
port, and port 26F owns a higher priority.
Operating mode
Three operating modes are supported: Standard Mode, Flow
Control-OFF and Port Isolation.
Performance
Switching mode
Store-and-forward
MAC address table
16 K
MAC address learning
Auto aging, auto learning
Dimensions (L x W x H)
440 mm ×240 mm ×44 mm
AC Input
100 - 240V AC, 50/60Hz, 0.4A
Lightning
protection
RJ45 port
Common mode: 4 kV
Power
Common mode: 6 kV; Differential mode: 6 kV
Operating environment
Temperature: 0°C - 45°C
Humidity: (10% - 90%) RH, non-condensing
Storage environment
Temperature: -40°C - 70°C
Humidity: (5% - 90%) RH, non-condensing

Product model
RG-ES126S
Transmission media
Ethernet: CAT3 UTP/STP or better
Fast Ethernet: CAT5 UTP/STP or better
Gigabit Ethernet: CAT5e or CAT6 UTP/STP
1000Base-SX: MMF (Multi-Mode Fiber)
1000Base-LX: MMF (Multi-Mode Fiber) or SMF (Single Mode
Fiber)
Network standard
IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
EMC Standards
GB9254-2008
Security Standards
GB4943-2011
如需了解产品及安装方面的更多信息，请登录锐捷网络网站 www.ruijie.com.cn
For more information about the product and installation procedures, log in to
www.ruijie.com.cn
锐捷网络股份有限公司 版权所有，保留一切权利
Copyright © ruijie networks Co., Ltd.
RUIJIE NETWORKS CO., LTD.
Ruijie Science and Technology Park, Juyuanzhou, No. 618, Jinshan Road, Fuzhou
Technical Support: http://bbs.ruijiery.com Technical Support Hotline:
[phone](China)
Website: http://www.ruijiery.com http://www.ruijie.com.cn
锐捷网络股份有限公司
福州市金山大道 618 号橘园洲工业园区星网锐捷科技园

技术支持：http://bbs.ruijiery.com 远程技术服务中心：[phone](China)
官网：http://www.ruijiery.com http://www.ruijie.com.cn