RUKO C11 User manual

P1: There are scraches on the car shell
A1: There is a protective film on the car shell to protect the car, please tear it off.
P2: The car doesn't work
A1: Please check if the power switch is on.
A2: Please check if the battery need to charge or replace.
P3: The car doesn't respond to the remote control
A1: Please check if the car power switch is on.
A2: Please check if the car has paired with the remote control successfully, restart the car
and the remote control.
A3: To check if the transmitter still has power.
P4: Water leaked into the battery compartment
A1: The cover isn't fasten, please ensure to lock the four cover tabs in 45 degree
A2: Turn off the car, take out the battery and clean the battery comparment and make it dry.
P5: The battery charging time is longer than 5-6hrs
A1: Please check if you use the appropriate charger, we suggest to use charger with output
current 5V≥3A.
A2: Please check if there is any damage on the battery.
P6: The car can't drive in a straight line
A1: Please adjust the trimmer on the bottom
(1)(2)(3)(4)(5)(6)

THE CAR AND THE TRANSMITTER
(1)CHOCKING HAZARD - Small parts. Keep out of reach of small children
(2)Adult Supervision is required, do not give this product to children under 8 years old.
Like other electrionic products, use this product safely to avoid electric shock.
(3)Keep away from fire, hot or humid enviroment.
(4)Always disconnect the batteries in the model when it is not in use.
(5)Most importantly, use good common sense at all times.
Turn on the car and transmitter, wait the the frequency paired.
turn
please adjust the trimmer on the car bottom.
Power SwitchTrimmerPower IndicatorLeft, RightForward, BackwardPower SwitchBattery CompartmentBattery Compartment
Use the transmitter to control the RC car's run forward and backward, and use the wheel to
control direction.

Press here
HOW TO REPLACE THE BATTERY?
Ba�ery parameters：Ba�ery type: NI-MH
Ba�ery voltage: 9.6V
Ba�ery capacity: 900mAh
Charging Time: 5~6hours
please rotatethis tab
Ba�ery Case Groove
Connect the battery cable
and put it into the groove
Make sure the power switch is on "OFF".
Remove the battery cover, keep pressing the connector buckle and pull the cable
off at the same time.
Connect the wire connector of the battery. Put the wire in the groove of the battery
compartment.
Restore the battery cover and fasten the tab of the cover.
output