RUKY RUKYMOTO User manual
MADE IN GERMANY
USER MANUAL
RUKYMOTO
!
WARNING
FOR AGES 1.5 & UP MAX. WEIGHT 20 KG
TO AVOID SERIOUS INJURY: Continuous adult supervision re-
quired; never use near moto vehicles; never use near streets,
swimming pools, hills, steps or sloped driveways. Always wear
shoes when using the ride-on vehicle. Never allow more than 1
riders.
Adult assembly required. Choking hazard to children under the
age of 3 years - contains small parts prior to assembly.
Introduction
Congratulations on the purchase of this RUKY vehicle. You
have acquired a quality product that will certainly give you
great pleasure.
This manual contains information on the safe use of your
vehicle and its care. Please read these information care-
fully before using the vehicle for the rst time and keep in
a safe place for future reference! Failure to observe the in-
formation contained in this manual may impair the safety of
your child. Should you have any questions, please contact
your dealer or contact us via our website www.ruky.de.
Warnings!
In order to prevent accidents or injuries occuring later, the
assembly must be carried out very carefully by an adult.
Take sucient time to do this. Several assembly steps
require manual skill and practise in handling tools (e.g.
spanner). If you are unsure, then please contact your
specialist dealer or a workshop.
This toy has potentially some sharp edges. Use only in
suitable terrain with no obstacles and level surface. This
vehicle does not comply with the requirements of German
Road Trac Regulations (StVZO). Not to be used by
children over 36 months (insucient stability). This product
has no brake.
Concept
RUKYMOTO is an ergonomically-designed children’s
vehicle which closes the gap between a four-wheel ride-on
vehicle and a two-wheel balance bike. It permits children
who can already walk well to ride more dynamically and
sportily than on a classic ride-on car, and yet oers more
anti-tip stability (2-wheel rear axle) than a balance bike.
Liability
The legal liability for material defects applies. Damages
caused by inappropriate use, the eects of force, insuf-
cient maintenance or due to normal wear and tear are
excluded from the liability of material defects.
Parents’ responsibility
Risks during play are, for the most part, excluded when
used in accordance with the intended purpose. However,
please take into consideration that unforeseen situations
and hazards may occur as a result of the natural need for
movement and the temperament of young children and
adolescents for which the manufacturer cannot be held
liable. Teach children and teenagers how to use the vehicle
correctly, in order to avoid falls and collisions.
Type label
The type label is located underneath the frame. Please re-
cord the information on the identication plate in the cycle
passport at the end of this manual so that you have all the
information you need in the event of any questions or when
ordering spare parts.
Maintenance and care
Before use, check all parts for possible wear as well as
screw connections for proper seating. Self-tightening nuts
are hard to loosen and must be replaced after complete
disassembly!
In order to maintain the high, design-specied safety levels,
all worn or defective parts are to be immediately replaced
by original RUKY spare parts. For safety reasons, the
vehicle should not be used until it has been fully repaired.
Bent or deformed parts should not be repaired but instead
should be replaced.
Spare parts: Wheels, handlebar grips
The vehicle may not be cleaned with a high-pressure
cleaner. Clean the vehicle using a mild soapy solution
and carefully wipe dry using a soft cloth. Keep the vehicle
away from corrosion-promoting materials (road salt, sea
water, fertiliser). The vehicle may not be stored in damp
conditions.
Unpacking and scope of delivery
Do not use any sharp objects when opening the packaging
and removing protective material. By doing so, you may
damage the paint or parts of the vehicle.
Check that the delivery is complete and undamaged. If
anything is missing, please contact your dealer before you
start to assemble the vehicle.
Small parts which are required during assembly (e.g.
screws and washers) must be kept out of the reach of
small children. Also keep all packaging materials away
from children. There is a danger of suocation as a result
of swallowing the parts.
In some cases, it is necessary to tighten screws with a
prescribed torque. This torque value is stated in Newtons
(e.g. 2 Nm). If the torque with which a screw is tightened is
too low, the connection may still be too loose and therefore
unsafe. If the torque is too high, screws and other parts
may be damaged or destroyed.
Scope of delivery
• Frame incl. seat
• Fork incl. front wheel
• Handlebar
• Rear axle with wheels
You require the following tools for assembly
(not included in scope of delivery)
• Allen key 5mm
!
!
!
Remove transport restraint (paperboard, rubber band) and
take o the washer.
Slide the steering tube onto the fork shaft, until it reaches
the stop. Make sure that the steering head is aligned
correctly (!) Add the washer. Align the nibs on the fork shaft
to face backwards (!).
Slide the handlebar all the way onto the fork shaft, and
tighten the screw. Align the slot in the handlebar with the
rear (!) Firmly press down on the spherical cap until it
snaps into position.
Unscrew screws from rear axle.
Insert the rear axle into the frame in the desired orientation
- Seat height Min (27cm) or seat height Max (29 cm).
1
3
5
2
4
1
2
1
2
5-8NM
1
2
................
.............
.............
Seat position
LOW
Seat position
HIGH
Seat adjustment
Adjust the seat height by turning the rear axle - Seat height Min (27cm) or seat height Max (29 cm).
VEHICLE PASSPORT
Please complete the information from the type label
so that you have all the information you need in the
event of any questions or when ordering spare parts.
Type label
MIN
MAX
2729
Subject to alterations Art. Nr. 43829 03.2019/V1
Other RUKY Bicycle manuals
