5
USING YOUR COFFEE MAKER
1. Open the water tank lid and fill the water tank with cold drinking water. The water level
should not exceed the MAX level as indicated on the water gauge.
2. Swing the funnel holder out, put the funnel into the funnel holder, then place the filter
paper in the funnel. Make sure it is assembled correctly.
3. Add ground coee to the paper filter. Usually a cup of coee needs one level spoon of
ground coee, but you may adjust according to personal taste. Close the funnel holder.
A click sound will be heard when the funnel holder is closed completely.
4. Place the coee pot on the warming plate.
5. Plug the power cord into the power outlet.
6. Press the switch down. The indicator will be illuminated. The appliance will begin working.
NOTE! During the brewing process, you may remove the coee pot to serve coee
for a duration of no more than 30 seconds, and the coee maker will stop dripping
automatically. If the serving time exceeds 30 seconds, the coee will overflow the
funnel.
7. Once the coee is brewed, one minute after the coee stops dripping out, remove the
coee pot, pour and serve.
NOTE! The brewed coee you get will be slightly less than the water you have added as
some water is absorbed by the ground coee. DO NOT touch the cover, warming plate
and so on during operation as they are very hot.
8. When the process is finished, if you do not want to serve immediately, leave the
appliance on. The coee can be kept warm on the warming plate for 40 minutes and the
appliance will switch o automatically after 40 minutes. For an optimum coee taste,
serve just after brewing.
9. Always turn the coee maker o and disconnect the power supply after use.
CAUTION! Be careful when pouring the coee out, as you may burn yourself as the
temperature of freshly brewed coee is very hot.
CLEANING AND MAINTENANCE
CAUTION! Always unplug the product from the electrical outlet and allow the warming
plate to cool completely before cleaning it. Never immerse the unit or power cord in water
or any other liquid for cleaning.
1. Clean all detachable parts after each use in hot, soapy water.
2. Wipe the product’s exterior surface with a soft, damp cloth to remove any stains.
3. Water droplets may build up in the area above the funnel and drip onto the product base
during brewing. To control the dripping, wipe o the area with a clean, dry cloth after
each use of the product.
4. Use a damp cloth to gently wipe the warming plate. Never use an abrasive cleaner to clean it.
5. Replace all parts and keep for next use.
