Rutland County Kindling shelf User manual

Assembly Instructions
Kindling shelf
1
Before you commence the assembly process we recommend that you read these instructions
thoroughly beforehand to familiarise yourself with the assembly process and to also check that you have
the correct components. If for any reason you need assistance, you can find our contact details on the
final page of these instructions.
We highly recommend that any assembly is carried out on a flat, level surface if possible and that you
use another person to assist you if necessary.
Package contents
Tools required
1 x Kindling shelf
2 x End supports
1 x Optional centre support
65mm fixing screws
Electric screwdriver with No2 Pozidrive bit
Or No2 Pozidrive Screwdriver
Kindling shelf

Kindling shelf
Rutland County Garden Furniture Ltd, Ashbourne House, 2 Dovecote Meadows,
Aslackby, Sleaford, Lincs, NG34 0HZ.
Company No: 7670072 VAT No: 151744027
2
Step 1
Step 2
If you are assembly a new log store proceed as
normal until the stage where you are ready to add
the roof as shown. For a pre-assembled log store
simply remove the roof. Please note: For single bay
log stores the following steps can be carried out
with the roof fitted.
Take one of the end supports and line it up at one
end of your log store at the required height -
remember to take account of the roof overhang.
Using the side panel slats as a guide, hold the support
level and screw into the side panel batten as shown.
Step 3
Step 4
Ensuring that the support is still level, now secure it
with another screw at the other end. Repeat this
process for the other end, again using the slats in the
panels to ensure that both supports are at the same
height. If you have a single bay log store (Burley or
Greetham) now proceed to step 6.
Now fit the centre support by using the slats in the
back panels as a guide and referring to the position of
the end supports to get the correct fitting height.
Screw into the back post after first ensuring that the
front of the support sits flush against the side of the
front post as shown in step 5.

Kindling shelf
Rutland County Garden Furniture Ltd, Ashbourne House, 2 Dovecote Meadows,
Aslackby, Sleaford, Lincs, NG34 0HZ.
Company No: 7670072 VAT No: 151744027
3
Step 5
Step 6
Now secure the front end of the centre support using
same method used to secure it at the rear.
Now lower the kindling shelf into place and attach or
replace the roof as necessary. For slatted log stores
the kindling shelf will need to be lowered vertically
between the openings near the rear of the side
panels (highlighted above) first.
We hope that you found your product quick and easy to assemble but if not and you require any
further assistance or have any questions you can contact us by telephone on: 01778 440803
Email: [email protected]
www.rutlandcountygardenfurniture.co.uk