
Set-Up
NOTE: If this is the initial setup, please remove TWO (both) insulator strips located under
the pill tray. One insulator is for the clock and the other insulator for the alarm.
CLOCK - Setting the Clock:
1. Slide the left side switch to T-SET.
2. Press the HOUR button to set the correct Hour. Please observe the PM indicator.
3. Press or hold the MINUTE button to set the correct Minutes.
4. If necessary press the 12H/24H button after setting the time to switch between 12 hour
(AM/PM) format and 24 hour format.
5. Slide the switch back to TIME.
ALARM TIME(S) - Setting the Alarm Time(s):
For each alarm slide the left switch (Alarm#) to 1, 2, 3 or 4.
1. Slide the left switch to the alarm you want to set.
2. Press ALARM ON/OFF button. A “pill” symbol appear with the alarm #.
3. Press or hold the HOUR button to set the correct Hour. Please observe the PM indicator.
4. Press or hold the MINUTE button to set the correct Minutes.
5. Slide the switch back to TIME. Repeat for each alarm you want to set.
ALARM MODE - Setting the Alarm Mode:
Select how you want to be notified when the alarm goes off. The setting applies to all alarms.
1. Slide the right switch to set desired alarm mode. VIB (Vibrating Alarm), BEEP (Beeping
Alarm) or VIB+BEEP (both).
Reminder Time –How to use
ALARM Beep/Vibrate - What to do when the ALARM goes OFF:
1. ALARM will beep/vibrate (or both) for 30 seconds. The alarm will repeat twice - 4
minutes and after 8 minutes after initial alarm. While the alarm is beeping/vibrating you
will see:
a. A flashing “Pill Symbol”
b. The Alarm # (1, 2, 3 or 4) corresponding with the proper pill box on the back
c. The scheduled alarm time
2. TAKE your MEDICATION(S).
3. After you have taken your medication(s), press ROUND button (ALARM ON/OFF).
4. The alarm will go off again tomorrow at the same time.
Other