Ryobi P400 Quick setup guide

RYOBI P400
CORNER CAT TM
FINISHING SANDER
REPAIR SHEET

2
RYOBI 18 VOLT CORNER CAT™ P400
FINISHING SANDER
PARTS LIST
KEY PART
NO. NUMBER DESCRIPTION QTY.
1 019001001016 PLATEN COVER .................................................................................................. 1
2 019001001015 SELF-TAPPING SCREW (4 X 8)........................................................................... 5
3 019001001017 PLATEN SUPPORT.............................................................................................. 1
4 940301034 DATA PLATE ........................................................................................................ 1
5 940114119 LOGO PLATE....................................................................................................... 1
200292003 LANYARD (NOT SHOWN) ................................................................................... 1
The model number will be found on a plate attached to the motor housing. Always mention the model number
in all correspondence regarding your FINISHING SANDER or when ordering repair parts.
1
2
3
5
4

3
RYOBI 18 VOLT CORNER CAT™ P400
FINISHING SANDER
1
2
3
4
5
6
PARTS LIST
KEY PART
NO. NUMBER DESCRIPTION QTY.
1 019001001023 SANDPAPER (60 GRIT) ....................................................................................... 2
2 019001001024 SANDPAPER (120 GRIT) ..................................................................................... 3
3 019001001025 SANDPAPER (240 GRIT) ..................................................................................... 2
4 019001001026 SCRUB, HEAVY................................................................................................... 1
5 019001001027 SCRUB, LIGHT.................................................................................................... 1
6 019001001028 SCRUB, POLISHING ........................................................................................... 1
983000622 OPERATOR'S MANUAL
983000622R REPAIR SHEET (REV:00)
12-13-04
The model number will be found on a plate attached to the motor housing. Always mention the model number
in all correspondence regarding your FINISHING SANDER or when ordering repair parts.