Safavieh Furniture HAC1017A User manual

NOTICE
Item ID: HAC1017A
PREPARATION Product Size: L29.53"xW11.81"xH53.15"
CARE AND MAINTENANCE
PIECE
Weight Capacity: 176 LBS
Warning: Do not stand on Table.
G
Shelf Divider
3X
H
Shelf Ledge
4X
E
Straight Lower Pole
2X
F
Bent Lower Pole
2X
I
Plastic Clip
40X
J
Leveling Feet
4X
C
Shelf Frame
1X
WARNING
D
Upper Pole
4X
A
Bottom Shelf
1X
B
Upper Shelf
3X
* Please make sure that you have all parts indicated and they are in good condition before you begin
assembly of this item. Refer to part list and hardware list below for guidance.
* This item should be assembled on a soft surface to prevent scratching the finish during assembly.
* This item may require periodic tightening.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email
[email protected]
* Before beginning assembly of product, make sure all parts are present. Compare parts with part
contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 10 minutes.
* Tools Required for Assembly (included): No.
*Never use abrasive or acid-based cleaners on the shelf rack.
*Clean shelves and rods with a solution of mild detergent and water. Use a soft cloth or sponge to
wipe parts. Rinse and dry thoroughly.
*Keep surfaces dry and clean for a longer lasting finish.
Part List and Hardware List
DESCRIPTION
PICTURE
QUANTITY

PREPARATION
STEP 7: FASTEN SHELF DIVIDERS(G) ONTO THE
FRAMES OF THREE PIECES UPPER SHELVES
PICTURED ABOVE.
STEP 8: PUSHING FIRMLY DOWN ON EACH SHELF AT ITS CORNER OVER PLASTIC CLIPS AND SCREW
LEVELING FEET TO ATTAIN PROPER LEVELING.
STEP 4: SCREW UPPER POLES(D) INTO EACH
LOWER POLE BY SCREW CONNECTORS ASSMBLED
ON UPPER POLES.
STEP 5: REFER TO STEP 3 TO ASSEMBLE THE
REMAINING TWO PIECES UPPER SHELVES
PICTURED ABOVE FIRSTLY. THEN ASSEMBLE
SHELF FRAME(C) ON THE TOP OF POLES.
STEP 6: JAM SHELF LEDGES(H) ONTO THE FRAMES
OF TWO PIECES UPPER SHELVES AND MAKE
THEM FIXED WITH THE ADJACENT POLES AS
SHOWN IN THE PICTURE.
* Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 10 minutes.
* Tools Required for Assembly (included): No.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email [email protected]
STEP 1: SCREW LEVELING FEET(J) INTO BOTTOM
OF EACH STRAIGHT LOWER POLE(E) AND BENT
LOWER POLE(F). SNAP PLASTIC CLIPS(I) ONTO
SAME GROOVES OF LOWER POLES.
STEP 2: HOLD BOTTOM SHELF(A) ON ITS SIDE
AND SLIDE IT FROM THE TOP OF EACH LOWER
POLE DOWN ONTO THE PLASTIC CLIPS.
STEP 3: REFER TO STEP 1&2 TO SNAP PLASTIC
CLIPS ONTO SAME GROOVES OF LOWER POLES
TO ASSEMBLE THE FIRST UPPER SHELF(B).