Safavieh Furniture Martell FOX8513 User manual

Model# FOX8513
Product Dimensions: 26.6"W*27.2"D*41.7~45.7"H
PIECE QUANTITY
A1X
B1X
C1X(R,L)
D1X
E1X
F1X
G5X
HW1 2X
HW2 6X
HW3 4X
HW4 8X
HW5 4X
HW6 2X
Part List and Hardware List
Arms (R & L)
DESCRIPTION PICTURE
Back Cushion 21.26"W*19.69"H*2.36"T
Seat Cushion 22.05"W*31.5"H*3.15"T
CARE AND MAINTENANCE
NOTICE
Star Base
Control Mechanism
Cylinder Column
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* This item may require periodic tightening
Wipe clean with a soft, dry cloth. The seat board can be cleaned with a mild cleaner. Test the cleaning
method on a hidden area before using them over the entire area .
Flat Washer 6.5MM
Screw Cover
Allen Wrench
Caster
Medium Phillips Screws6x0.5x30MM
Socket Screws 8x0.6x50MM
Short Phillips Screws6x0.5x25MM

Step 1 Step 2 Step 3
Step 4 Step 5 Step 6
Connect the armrests(3) to seat(2) by using four
Long Screws(10) and four Screw Covers(12).
Now insert the small end of Cylinder Column (5)
into Control Mechanism (4) and carefully press
downward with moderate force until it is fully
seated.
The chair is ok now.
ATTENTION: MAKE SURE ALL SCREWS ARE
FULLY TIGHTENED BEFORE USING CHAIR
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents
list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Wrench
Insert five Casters (7) into Star Base (6), push
hard until you feel or hear the Caster(7) snap
into place. Insert the LARGE end of Cylinder
Column (5) into the Star Base (6) and carefully
press downward with moderate force until it is
fully seated.
Attach Control Mechanism (4) to Seat Assembly (2)
with the arrow towards the front of the chair, using
four Washers (11) and two Short Screws(8),two
Medium Screws(9).
Assemble the Seat(2) to the Back(1)
together,using four Medium Screws(9) and
four Washers(11).
FULLY TIGHTEN ALL SCREWS USING
ALLEN WRENCH