SafeTrust SABRE User manual

The SABRE Module offers a quick Bluetooth
mobile access upgrade for legacy readers with
a Hiroseconnector.*
Remove the mounting screw at the bottom of
the reader.
Once the screw is removed pull the reader out
and up to remove it from the wall mount
bracket.
The Hiroseconnector is hidden behind black
electrical tape. By peeling the tape the
connector will become accessible.
The SABRE module has a matching Hirose
connector that will plug into the host reader.
Position the SABRE module (with logo
up), onto the Hiroseconnector and press
firmly to make a connection.
Once a connection is made between the
Hiroseconnectors, the module will start to
receive power and within seconds will be
operational.
With the SABRE module connected, re-mount
the reader onto the wall and reinsert the
mounting screw.
Open the Safetrust Wallet APP and select Manage
Sensor tab. Make sure your system admin has set
you up with this role.
www.Safetrust.com
Quick Start Guide
SABRE Module

With the Manage Sensor tab open from the
App, bring the phone in range of the
SABRE Module and once visible from the
App, highlight and select “Configure”.
Select the corresponding IDENTITY SYSTEM
from the drop down box. Assign a short “Name”
and “Description” using alphanumeric characters.
Enable the slider for “Self Enrollment” if you
intend to allow your users to enroll mobile
credential using their existing legacy cards from
this reader. Click ‘Save’ to successfully complete
reader configuration.
When the SABRE Module information is
successfully saved to the Credential Manager,
and assigned to the Identity System, the new
description will appear in the Manage Sensor
with a unique serial number assigned.
The two main configuration options for this are the
“Sensitivity Level to Activate” slider, which
determines how easily your mobile device with
pick up the activation zone, and the “Anti
Passback” setting, which defines the
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Exposure: Mobile RF exposure device, there shall be a minimum separation of 20 cm between the device
and any users or installers.
Canada RadioCertification
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
To open the door, simply present your mobile device
running the Safetrust Wallet application to the
SABRE Module. When the phone is within the
configured activation range, the LED within the
assigned credential for this identity system will be
green in color. If “Auto Authenticate” is enabled, the
credential will be sent to the SABRE Module
whenever the mobile device is within range.
within the activation zone.
Quick Start Guide
SABRE Module
www.Safetrust.com
[e-mail]
+1 510 9 SAFE 09
SAFETRUST SABRE Module
Model: SA220
FCC ID: 2ANI5SA220
IC ID: 23133-SA220
M A D E I N U S A