Safety 1st Store 'n Go Sport User manual

To see installation videos, scan the QR Code
or visit www.safety1st.com
©2017 Dorel Juvenile.
Store ‘n Go Sport
2-in-1 Booster
40-110 lb (18.1-49.9 kg)
43-57 in. (110.1-144.8 cm)
KEEP INSTRUCTIONS FOR FUTURE USE.
Read all instructions before using
this booster seat.
4358-7323
7.10.17
Failure to follow the warnings on the labels and
in the instruction manual can result in serious
injury or death to your child.

Table of Contents
Getting Started............................1
Parts of the Booster Seat..............................1
General Use ..................................3
Preparing Seat.............................................3
Installing Seat Pad..................................3
Attaching Headrest to Backrest................5
Attaching Backrest to Base.....................5
Adjusting Backrest .................................6
Adjusting Headrest.................................6
Removing Backrest.................................7
Storage Drawer......................................8
Removing Seat Pad for Cleaning..............9
Safety Information......................11
Booster Seat Use..........................................11
Installation in Vehicle....................................12
Vehicle Seating Position................................12
Vehicle Information....................14
Understanding Your Vehicle...........................14
Knowing Your Vehicle Belts............................15
Aircraft Information ......................................16
Booster Seat with Backrest......17
Lap and Shoulder Belt Installation...........18
Booster Seat without Backrest..20
Lap and Shoulder Belt Installation...........21
Important Information...............23
Dorel Juvenile Group Information...................23
Registration and Safety Notices.....................24
Troubleshooting............................................25
Replacement Parts Order Form......................26
Warranty......................................................28
© 2017 Dorel Juvenile

12
Front View
A. Headrest
B. Shoulder Belt-
Positioning Guide
C. Backrest
D. Armrest
E. Seat Base
F. Storage Drawer
G. Storage Drawer Lock
H. Cup Holder
I. Plastic Snap Strip
For Seat Base Pad
A
B
C
D
H
E
F
Back View
A
B
C
E
H
J
L
J. Headrest Adjustment Lock
K. Instruction Manual
Storage (under seat bottom)
L. Backrest Lock
(under the seat bottom)
GK
I.
Parts of the Booster Seat

34
4.Attach Headrest Pad
Slide the headrest pad over
one side of the headrest, then
the other.
From the back of the
headrest, attach the elastic
straps to the hooks at the top
and bottom.
5. Attach Backrest Pad
Slide backrest pad onto one
side of the backrest. Pull
pad tight and slide the pad
over the other side of the
backrest.
Bottom of the headrest
pad should be behind the
backrest pad as shown.
WARNINGS: Do not use this booster seat
without the seat pad. Failure to do this can result
in serious injury.
2. Attach Seat Base Pad
Push in the locking tabs into
the holes on the front of the
seat base.
Preparing Seat
1. Insert Plastic Snap Strip
into Front of Seat Pad
Push locking tabs in the
holes on the front of the
seat base pad, as shown.
Note: Depending on your model, you may need to
prepare the seat for use.
Installing Seat Pad
3. Fasten Elastic Straps to
Bottom of Seat Base
From bottom of seat base,
fasten elastic straps.

56
Note: Headrest MUST always be used when using backrest.
If headrest has been removed from backrest.
1. Find Backrest
Connection Slot
Lift flap on seat pad as
shown to reveal backrest
connection slot.
2. Attach Backrest to
Seat Base
Insert the hook on the
backrest into the backrest
connection slot.
Make sure backrest is laying flat (horizontal) when
connecting.
3. Rotate Backrest Up Until It
Clicks into Place
Tuck seat pad flap under
backrest flap.
Attaching Backrest to Base
1. Rotate Backrest Forward
or Back to Desired Position
The backrest should be flush
with vehicle seat back angle.
NOTE: The backrest and headrest are removable. The
headrest and backrest must always be used together.
To use as a backed booster, attach headrest to backrest
and backrest to seat base, as follows.
With the back of the headrest
and backrest facing up, slide the
headrest into the track on the
back of the backrest.
Pull headrest adjuster lock out
and pull headrest down into a
locked position.
Attaching Headrest to Backrest
NOTE: Make sure seat pad does not get caught between
the moving parts. The backrest may not connect properly
if the pad is in the way.
Adjusting Backrest
1. Raise or Lower Headrest to
Selected Position
This booster seat has multiple
headrest positions. Grasp top of
headrest and push down with
one hand while pulling out on
the headrest adjustment lock
with the other.
Raise and lower headrest into
selected position. Release
the headrest adjustment lock
into one of the many headrest
heights.
Make sure headrest is locked by sliding headrest up and
down. Headrest may move slightly when it is locked.
Adjusting Headrest

78
1. Unlock the Backrest
Locate the backrest lock and
pull the tab down. At the same
time, lay the base down so
that the seat is flat.
2. Remove Backrest
from Seat Base
With the seat base and
backrest lying flat, lift up
on the backrest to release
the backrest hook from the
seat base.
Removing Backrest
To open storage drawer:
Squeeze up on the drawer
lock and pull out.
To close storage drawer:
Push in drawer until it is
flush with the seat.
WARNINGS: Only use storage drawer for storing
your child’s gear. Keep storage drawer closed when
not in use. Failure to do this can result in serious
injury.
Storage Drawer

910
2. Pull the Lock Tabs
Out of Front of Base
1.Unfasten the Elastic
Strap on Bottom of
Base
4. Remove Backrest Pad
Pull backrest pad out
from around backrest
shell.
Removing Seat Pad
for Cleaning
3. Remove Plastic Snap
Strip from Front of
Seat Pad
Pull locking tabs out of the
holes on the front of the
seat base pad, as shown.
Remove plastic snap strip.
Place the snap strip in the
storage drawer so it does
not become lost.
5.Unfasten Elastic Straps
From the back of headrest,
unfasten the elastic straps.
6. Remove Headrest Pad
Gently pull pad off headrest.
Replacing Pad
To replace the pad, see pages 3-4.
Cleaning Seat Pad
Machine wash separately with cold water on a gentle
cycle. Do not use bleach. Tumble dry separately for
10-12 minutes on low heat. Remove immediately.

11 12
Never take your child out of the booster seat
while the vehicle is moving.
Never leave child unattended.
Placing your child in a hot booster seat may
result in burns.
Do not use a booster seat with damaged or
missing parts.
Do not substitute parts or try to modify the
booster seat in any way.
Do not use any booster seat accessory except
those approved by Dorel Juvenile Group.
Never allow any child to play with this booster
seat; it is not a toy.
Do not remove or cover up any of the warning
labels or other labels on the booster seat.
On the side of the booster seat there is a date of
manufacture label. Do not use this booster seat
more than 10 years after date of manufacture.
Read all instructions and warning labels for
additional warnings.
Check the vehicle belt before each use. Use only
if the belt can be tightened properly and securely.
This booster seat should be securely belted in
the vehicle even when not in use. In a crash or
sudden stop, an unsecured booster seat could
injure occupants.
Do not use a booster seat that has been in a
crash. You must get a new booster seat.
Booster Seat Use Installation in Vehicle
continued on next page.
Vehicle Seating Position
Check the vehicle owner’s manual for more
information about air bag/booster seat use.
For vehicles without a back seat, refer to your
vehicle owner’s manual.
Use the booster seat only on
vehicle seats that face forward.
Do not use on seats that face the
sides or rear of the vehicle.
Some vehicles do not have a seating position that can
be used safely with this booster seat. If you are not
sure where to place the booster seat in your vehicle,
consult your vehicle owner’s manual, contact Dorel
Juvenile Group Consumer Care Department, or visit
your local Child Passenger Inspection Station. Go to
http://www.safercar.gov/cpsApp/cps/index.htm to find
your closest station.

13 14
Children are safer when properly restrained in
rear seating positions than in the front seating
positions.
According to National Highway Traffic Safety
Administration information, children in rear
seating positions are statistically safer, whether
you have air bags, advanced air bags, or no air
bags at all.
To avoid your child being seriously burned, take
the following precautions:
1. Park in the shade or where sun does not directly
hit the booster seat.
2. Always use the booster seat with the seat pad.
Your vehicle’s features may be
considerably different than those pictured
here.
Consult your vehicle owner’s manual to
help identify your vehicle’s specific
features and locations.
Seat Bight
Vehicle
Seat Belts
Understanding Your Vehicle

15 16
Not all vehicle belts and seating positions will work
with booster seats.
You must review your vehicle’s owner manual for
vehicle seat belt use with booster seats.
Inflatable Seat Belts
Never UseWithThis
Booster Seat
Lap Belt Only
Knowing Your Vehicle Belts
This booster seat is not certified for
aircraft use because aircraft seats do
not have shoulder belts.
Aircraft Informaiton