Step 1: Place step panel under steps
with 28” post side (shorter side) on
the side that the door swings open.
Step 2: Attach shorter door panel to the short side of the
step panel by placing a short rod through the brackets of
each panel. (This allows the door to open completely
without contacting the fence.)
Step 3: Attach standard 32” panel to the tall side of
the step panel by placing a long rod through the
overlapping eyelets. (Long rods go into the ground
to make fence more secure.)
Step 4: If desired, place insert panel in
between the steps, as shown in the picture
below. This piece can rest inside the steps,
additional means of securing this piece is
optional.
Step 5: Continue attaching standard
32” panels to cover your desired
area. Note: Use long rods to connect
panels that will make a corner and
the gate.
Step 6: Use a long rod to attach the latch pin gate panel to a
standard 32” panel at your desired placement. Use latch gate
panel with a long rod to continue the assembly until the area
is completely enclosed. Use a Phillips head screwdriver to
assemble latch pin as shown below (screw length may vary).
